[U-Boot] [PATCH 2/2] ARM: sunxi: Enable DM MMC+SATA for the PcDuino3 Nano board

[Tuomas Tynkkynen]

On Wed, 2017-12-20 at 13:26 +0100, Maxime Ripard wrote:
> On Mon, Dec 18, 2017 at 10:09:42PM +0200, Tuomas Tynkkynen wrote:
> > After the previous commit which adds support for the cd-inverted
> > property to the sunxi MMC driver, driver-model MMC works fine on
> > this
> > board.
> > 
> > Signed-off-by: Tuomas Tynkkynen <tuomas at tuxera.com>
> > ---
> >  configs/Linksprite_pcDuino3_Nano_defconfig | 2 ++
> >  1 file changed, 2 insertions(+)
> > 
> > diff --git a/configs/Linksprite_pcDuino3_Nano_defconfig
> > b/configs/Linksprite_pcDuino3_Nano_defconfig
> > index 13538fafd1..44ce8b3ead 100644
> > --- a/configs/Linksprite_pcDuino3_Nano_defconfig
> > +++ b/configs/Linksprite_pcDuino3_Nano_defconfig
> > @@ -17,9 +17,11 @@ CONFIG_SPL_I2C_SUPPORT=y
> >  # CONFIG_SPL_ISO_PARTITION is not set
> >  # CONFIG_SPL_EFI_PARTITION is not set
> >  CONFIG_SCSI_AHCI=y
> > +CONFIG_DM_MMC=y
> >  CONFIG_ETH_DESIGNWARE=y
> >  CONFIG_RGMII=y
> >  CONFIG_SUN7I_GMAC=y
> >  CONFIG_SCSI=y
> > +CONFIG_DM_SCSI=y
> 
> Those should not be in a single defconfig, but enabled for all the
> Allwinner boards (that have SATA and MMC).
> 
> Maxime
> 

Makes sense. I don't have any other boards to test with so I just
imitated Simon's change for the non-Nano pcduino3.

I will try to see if this could be imply'd in Kconfig.