[U-Boot] [PATCH] ARM: sunxi: Remove left-over cd-inverted property from pcDuino3

[Tuomas Tynkkynen]

Commit 8620f384098b ("dm: sunxi: Linksprite_pcDuino3: Correct polarity
of MMC card detect") claims that the Pcduino3 device tree had an
incorrect polarity for the card detect pin and thus changed the polarity
flag of the cd-gpios from GPIO_ACTIVE_HIGH to GPIO_ACTIVE_LOW.

Actually the DT was correct since according to the mmc binding, a
combination of GPIO_ACTIVE_HIGH + cd-inverted results in an active-low
polarity. But because the U-Boot driver lacks the code to look at the
cd-inverted property (unlike the Linux driver) it interpreted the
polarity of active-high. Thus, after that commit the DT is actually
wrong from the binding/Linux point of view.

To make both Linux and U-Boot interpret the DT in the same way, just
drop the left-over cd-inverted property. I've sent a Linux patch to
switch all sunxi DTs over to not using the cd-inverted property, so
eventually all sunxi boards in U-Boot will be consistent in not using
cd-inverted.

Signed-off-by: Tuomas Tynkkynen <tuomas at tuxera.com>
---
This patch supersedes the following two patches:
- [PATCH 1/2] mmc: sunxi: Support cd-inverted DT property
- [PATCH 2/2] ARM: sunxi: Enable DM MMC+SATA for the PcDuino3 Nano board

 arch/arm/dts/sun7i-a20-pcduino3.dts | 1 -
 1 file changed, 1 deletion(-)

diff --git a/arch/arm/dts/sun7i-a20-pcduino3.dts b/arch/arm/dts/sun7i-a20-pcduino3.dts
index 37b1e0ee9b..7f449b6a28 100644
--- a/arch/arm/dts/sun7i-a20-pcduino3.dts
+++ b/arch/arm/dts/sun7i-a20-pcduino3.dts
@@ -165,7 +165,6 @@
 	vmmc-supply = <&reg_vcc3v3>;
 	bus-width = <4>;
 	cd-gpios = <&pio 7 1 GPIO_ACTIVE_LOW>; /* PH1 */
-	cd-inverted;
 	status = "okay";
 };
 
-- 
2.15.0