[U-Boot] [PATCH 00/23] Fix and extend i.MX HAB layer

[Bryan O'Donoghue]

On 28/12/17 17:54, Breno Matheus Lima wrote:
> Hi Bryan,
> 
> 2017-12-27 10:25 GMT-02:00 Bryan O'Donoghue <bryan.odonoghue at linaro.org>:
>> This patchset updates the i.MX HAB layer in u-boot to fix a list of
>> identified issues and then to add and extend existing functionality.
>>
>> The first block of patches 0001-0006 deal with fixing existing code,
>>
>> - Fixes indentation
>> - Fixes the treatment of input parameters to hab_auth_image.
>>
>> The second block of patches 0007-0013 are about tidying up the HAB code
>>
>> - Remove reliance on hard-coding to specific offsets
>> - IVT header drives locating CSF
>> - Continue to support existing boards
>>
>> Patches 0014 onwards extend out the HAB functionality.
>>
>> - hab_rvt_check_target is a recommended check in the NXP documents to
>>    perform prior to hab_rvt_authenticate_image
>> - hab_rvt_failsafe is a useful function to set the board into BootROM
>>    USB recovery mode.
>>
>> Bryan O'Donoghue (23):
>>    arm: imx: hab: Make authenticate_image return int
>>    arm: imx: hab: Fix authenticate_image result code
>>    arm: imx: hab: Optimise flow of authenticate_image on is_enabled fail
>>    arm: imx: hab: Optimise flow of authenticate_image on hab_entry fail
>>    arm: imx: hab: Fix authenticate_image input parameters
> 
> After applying "[PATCH 05/23] arm: imx: hab: Fix authenticate_image
> input parameters" I'm getting the following error when building
> mx6sabreauto:

That's funny. I just build mx6sabreauto_config + CONFIG_SECURE_BOOT and 
it works.

I'll rebase and build each patch incrementally - obviously there's some 
breakage with your configuration.

Thanks for testing