[U-Boot] [PATCH 7/8] mmc: sdhci-cadence: add HS200 support

Masahiro Yamada yamada.masahiro at socionext.com
Fri Dec 29 17:00:11 UTC 2017


Add HS200 timing setting and the MMC tuning callback.

Signed-off-by: Masahiro Yamada <yamada.masahiro at socionext.com>
---

 drivers/mmc/sdhci-cadence.c | 87 ++++++++++++++++++++++++++++++++++++++++-----
 1 file changed, 78 insertions(+), 9 deletions(-)

diff --git a/drivers/mmc/sdhci-cadence.c b/drivers/mmc/sdhci-cadence.c
index 921095b..8658126 100644
--- a/drivers/mmc/sdhci-cadence.c
+++ b/drivers/mmc/sdhci-cadence.c
@@ -52,6 +52,13 @@
 #define SDHCI_CDNS_PHY_DLY_HSMMC	0x0c
 #define SDHCI_CDNS_PHY_DLY_STROBE	0x0d
 
+/*
+ * The tuned val register is 6 bit-wide, but not the whole of the range is
+ * available.  The range 0-42 seems to be available (then 43 wraps around to 0)
+ * but I am not quite sure if it is official.  Use only 0 to 39 for safety.
+ */
+#define SDHCI_CDNS_MAX_TUNING_LOOP	40
+
 struct sdhci_cdns_plat {
 	struct mmc_config cfg;
 	struct mmc mmc;
@@ -135,20 +142,18 @@ static void sdhci_cdns_set_control_reg(struct sdhci_host *host)
 	 * The mode should be decided by MMC_TIMING_* like Linux, but
 	 * U-Boot does not support timing.  Use the clock frequency instead.
 	 */
-	if (clock <= 26000000)
+	if (clock <= 26000000) {
 		mode = SDHCI_CDNS_HRS06_MODE_SD; /* use this for Legacy */
-	else if (clock <= 52000000) {
+	} else if (clock <= 52000000) {
 		if (mmc->ddr_mode)
 			mode = SDHCI_CDNS_HRS06_MODE_MMC_DDR;
 		else
 			mode = SDHCI_CDNS_HRS06_MODE_MMC_SDR;
 	} else {
-		/*
-		 * REVISIT:
-		 * The IP supports HS200/HS400, revisit once U-Boot support it
-		 */
-		printf("unsupported frequency %d\n", clock);
-		return;
+		if (mmc->ddr_mode)
+			mode = SDHCI_CDNS_HRS06_MODE_MMC_HS400;
+		else
+			mode = SDHCI_CDNS_HRS06_MODE_MMC_HS200;
 	}
 
 	tmp = readl(plat->hrs_addr + SDHCI_CDNS_HRS06);
@@ -161,6 +166,68 @@ static const struct sdhci_ops sdhci_cdns_ops = {
 	.set_control_reg = sdhci_cdns_set_control_reg,
 };
 
+static int sdhci_cdns_set_tune_val(struct sdhci_cdns_plat *plat,
+				   unsigned int val)
+{
+	void __iomem *reg = plat->hrs_addr + SDHCI_CDNS_HRS06;
+	u32 tmp;
+
+	if (WARN_ON(!FIELD_FIT(SDHCI_CDNS_HRS06_TUNE, val)))
+		return -EINVAL;
+
+	tmp = readl(reg);
+	tmp &= ~SDHCI_CDNS_HRS06_TUNE;
+	tmp |= FIELD_PREP(SDHCI_CDNS_HRS06_TUNE, val);
+	tmp |= SDHCI_CDNS_HRS06_TUNE_UP;
+	writel(tmp, reg);
+
+	return readl_poll_timeout(reg, tmp, !(tmp & SDHCI_CDNS_HRS06_TUNE_UP),
+				  1);
+}
+
+static int sdhci_cdns_execute_tuning(struct udevice *dev, unsigned int opcode)
+{
+	struct sdhci_cdns_plat *plat = dev_get_platdata(dev);
+	struct mmc *mmc = &plat->mmc;
+	int cur_streak = 0;
+	int max_streak = 0;
+	int end_of_streak = 0;
+	int i;
+
+	/*
+	 * This handler only implements the eMMC tuning that is specific to
+	 * this controller.  The tuning for SD timing should be handled by the
+	 * SDHCI core.
+	 */
+	if (!IS_MMC(mmc))
+		return -ENOSYS;
+
+	if (WARN_ON(opcode != MMC_CMD_SEND_TUNING_BLOCK_HS200))
+		return -EINVAL;
+
+	for (i = 0; i < SDHCI_CDNS_MAX_TUNING_LOOP; i++) {
+		if (sdhci_cdns_set_tune_val(plat, i) ||
+		    mmc_send_tuning(mmc, opcode, NULL)) { /* bad */
+			cur_streak = 0;
+		} else { /* good */
+			cur_streak++;
+			if (cur_streak > max_streak) {
+				max_streak = cur_streak;
+				end_of_streak = i;
+			}
+		}
+	}
+
+	if (!max_streak) {
+		dev_err(dev, "no tuning point found\n");
+		return -EIO;
+	}
+
+	return sdhci_cdns_set_tune_val(plat, end_of_streak - max_streak / 2);
+}
+
+static struct dm_mmc_ops sdhci_cdns_mmc_ops;
+
 static int sdhci_cdns_bind(struct udevice *dev)
 {
 	struct sdhci_cdns_plat *plat = dev_get_platdata(dev);
@@ -189,6 +256,8 @@ static int sdhci_cdns_probe(struct udevice *dev)
 	host->ioaddr = plat->hrs_addr + SDHCI_CDNS_SRS_BASE;
 	host->ops = &sdhci_cdns_ops;
 	host->quirks |= SDHCI_QUIRK_WAIT_SEND_CMD;
+	sdhci_cdns_mmc_ops = sdhci_ops;
+	sdhci_cdns_mmc_ops.execute_tuning = sdhci_cdns_execute_tuning;
 
 	ret = mmc_of_parse(dev, &plat->cfg);
 	if (ret)
@@ -223,5 +292,5 @@ U_BOOT_DRIVER(sdhci_cdns) = {
 	.probe = sdhci_cdns_probe,
 	.priv_auto_alloc_size = sizeof(struct sdhci_host),
 	.platdata_auto_alloc_size = sizeof(struct sdhci_cdns_plat),
-	.ops = &sdhci_ops,
+	.ops = &sdhci_cdns_mmc_ops,
 };
-- 
2.7.4



More information about the U-Boot mailing list