[U-Boot] [u-boot PATCH v3 7/8] ARM: k2g: setup PRU ethernet MAC addresses

Roger Quadros rogerq at ti.com
Wed Feb 8 08:35:36 UTC 2017



On 07/02/17 05:22, Lokesh Vutla wrote:
> 
> 
> On 2/6/2017 3:06 PM, Roger Quadros wrote:
>> PRU ethernet MAC address range is present in the
>> board EEPROM. Parse it and setup eth?addr
>> environment variables.
>>
>> Signed-off-by: Roger Quadros <rogerq at ti.com>
>> Reviewed-by: Lokesh Vutla <lokeshvutla at ti.com>
>> ---
>>  board/ti/ks2_evm/board_k2g.c | 19 +++++++++++++++++++
>>  1 file changed, 19 insertions(+)
>>
>> diff --git a/board/ti/ks2_evm/board_k2g.c b/board/ti/ks2_evm/board_k2g.c
>> index 40edbaa..a738dd2 100644
>> --- a/board/ti/ks2_evm/board_k2g.c
>> +++ b/board/ti/ks2_evm/board_k2g.c
>> @@ -12,6 +12,7 @@
>>  #include <asm/arch/psc_defs.h>
>>  #include <asm/arch/mmc_host_def.h>
>>  #include "mux-k2g.h"
>> +#include "../common/board_detect.h"
>>  
>>  #define SYS_CLK		24000000
>>  
>> @@ -149,6 +150,24 @@ int board_early_init_f(void)
>>  }
>>  #endif
>>  
>> +#ifdef CONFIG_BOARD_LATE_INIT
>> +int board_late_init(void)
>> +{
>> +#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_TI_I2C_BOARD_DETECT)
> 
> You might want to select CONFIG_TI_I2C_BOARD_DETECT and
> CONFIG_BOARD_LATE_INIT for this to take effect. I do not see these
> configs enabled or am I missing something?

I was expecting k2g-ice board to have a new defconfig. But it seems that
we will continue to use k2g_evm_defconfig for that so I'll enable these
options there.

cheers,
-roger

> 
> Thanks and regards,
> Lokesh
> 
>> +	int rc;
>> +
>> +	rc = ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
>> +			CONFIG_EEPROM_CHIP_ADDRESS);
>> +	if (rc)
>> +		printf("ti_i2c_eeprom_init failed %d\n", rc);
>> +
>> +	board_ti_set_ethaddr(1);
>> +#endif
>> +
>> +	return 0;
>> +}
>> +#endif
>> +
>>  #ifdef CONFIG_SPL_BUILD
>>  void spl_init_keystone_plls(void)
>>  {
>>

-- 
cheers,
-roger


More information about the U-Boot mailing list