[U-Boot] ERROR: can't get kernel image!

[Borisa Jevtic]

Hi guys.

I have come across a bulletin that blames the problem (described bellow) on
the U-Boot bootloader:

https://e2e.ti.com/support/embedded/linux/f/354/t/73788

And this is a typical bootup sequence happening for us:

U-Boot 1.3.4 (Feb 28 2012 - 20:31:25) - AT91SAM9260 at 200 MHz -

DRAM: 64 MB
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Net: smc911x, macb0
main_loop: BootStatus=not_ok
main_loop: bootstatus_valid=0
main_loop: bootspace_target=1
main_loop: bootspace_target=1
main_loop: setting bootcmd to bootcmd1=nand read.jffs2 0x22000000
0x000c0000 0x00200000; bootm 0x22000000
main_loop: set BootSpace to 1
Erasing Nand...
Erasing at 0xa0000 – 100% complete.
Writing to Nand... done
main_loop: setting bootargs to bootargs1=mem=64M console=ttyS0,115200
ubi.mtd=6,512 ubi.mtd=9,512 root=ubi0:ipc3-rootfs rootfstype=ubifs
lpj=495616 loglevel=8 rw
Hit any key to stop autoboot: 0

NAND read: device 0 offset 0xc0000, size 0x200000

Reading data from 0x17d000 – 37% complete.reading NAND page at offset
0x17d800 failed
2097152 bytes read: ERROR

   1.
      1. Booting kernel from Legacy Image at 22000000 ...
      Image Name: Angstrom/2.6.27/ipc3
      Image Type: ARM Linux Kernel Image (uncompressed)
      Data Size: 1098224 Bytes = 1 MB
      Load Address: 20008000
      Entry Point: 20008000
      Verifying Checksum ... Bad Data CRC
      ERROR: can't get kernel image!
      Enter password:RomBOOT
      >


Is there any chance that you guys are aware of this problem and if it is
really a u-boot problem?
If so, do you know if this has been fixed and and in which version?

Thank you.

-- 
Boriša Jevtić