[U-Boot] [PATCH 12/12] sunxi: add a defconfig for SoPine w/ official baseboard

[Jagan Teki]

On Wed, Apr 26, 2017 at 8:20 PM, Icenowy Zheng <icenowy at aosc.io> wrote:
> The SoPine is a SoM by Pine64, with an Allwinner A64 SoC, a LPDDR3 DRAM
> chip, an AXP803 PMIC, a SPI NOR Flash and a MicroSD slot. The card
> detect pin of the MicroSD slot is broken, however, it doesn't matter as
> the design of SoPine didn't allow hot-swapping the MicroSD card (The
> MicroSD slot is at the back of the SoM, and when the SoM is installed on
> the baseboard, it's nearly impossible to remove the MicroSD).
>
> The official baseboard of it is a board with nearly the same connectors
> with the original Pine64+, with the MicroUSB power jack replaced, and
> at the position of MicroSD slot a eMMC module slot is added.
>
> Add support for SoPine with the official baseboard by adding its
> defconfig file. It still uses the device tree of Pine64, however, it
> will change after a proper device tree of SoPine with baseboard is
> accepted by Linux mainline.
>
> Signed-off-by: Icenowy Zheng <icenowy at aosc.io>
> ---
>  configs/sopine_baseboard_defconfig | 22 ++++++++++++++++++++++
>  1 file changed, 22 insertions(+)
>  create mode 100644 configs/sopine_baseboard_defconfig
>
> diff --git a/configs/sopine_baseboard_defconfig

Can't this be simply sopine_defconfig

Please add MAINTAINERS entry as well

thanks!
-- 
Jagan Teki
Free Software Engineer | www.openedev.com
U-Boot, Linux | Upstream Maintainer
Hyderabad, India.