[U-Boot] [PATCH 14/14] dm: sunxi: Move Linksprite_pcDuino3 to use DM for MMC, SATA

[Simon Glass]

Move this board over to driver model for MMC and SATA. This means that it
uses CONFIG_BLK as well. In SPL these options remain turned off since it
increases the code size. One option would be to use CONFIG_SPL_OF_PLATDATA
to avoid device-tree overhead.

Signed-off-by: Simon Glass <sjg at chromium.org>
---

 arch/arm/dts/sun7i-a20-pcduino3.dts   | 1 -
 configs/Linksprite_pcDuino3_defconfig | 7 ++++++-
 2 files changed, 6 insertions(+), 2 deletions(-)

diff --git a/arch/arm/dts/sun7i-a20-pcduino3.dts b/arch/arm/dts/sun7i-a20-pcduino3.dts
index 1a8b39be1d..d487c84562 100644
--- a/arch/arm/dts/sun7i-a20-pcduino3.dts
+++ b/arch/arm/dts/sun7i-a20-pcduino3.dts
@@ -164,7 +164,6 @@
 	pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>;
 	vmmc-supply = <&reg_vcc3v3>;
 	bus-width = <4>;
-	cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */
 	cd-inverted;
 	status = "okay";
 };
diff --git a/configs/Linksprite_pcDuino3_defconfig b/configs/Linksprite_pcDuino3_defconfig
index 6f4a02f8d4..f0d382c002 100644
--- a/configs/Linksprite_pcDuino3_defconfig
+++ b/configs/Linksprite_pcDuino3_defconfig
@@ -15,7 +15,12 @@ CONFIG_SPL_I2C_SUPPORT=y
 # CONFIG_SPL_DOS_PARTITION is not set
 # CONFIG_SPL_ISO_PARTITION is not set
 # CONFIG_SPL_EFI_PARTITION is not set
-CONFIG_SCSI=y
+# CONFIG_SPL_BLK is not set
+CONFIG_DM_MMC=y
+# CONFIG_SPL_DM_MMC is not set
+# CONFIG_SPL_DM_MMC_OPS is not set
 CONFIG_ETH_DESIGNWARE=y
 CONFIG_SUN7I_GMAC=y
+CONFIG_SCSI=y
+CONFIG_DM_SCSI=y
 CONFIG_USB_EHCI_HCD=y
-- 
2.13.1.518.g3df882009-goog