[U-Boot] [PATCH 14/14] dm: sunxi: Move Linksprite_pcDuino3 to use DM for MMC, SATA

[Simon Glass]

Hi Maxime,

On 20 June 2017 at 00:45, Maxime Ripard
<maxime.ripard at free-electrons.com> wrote:
> Hi Simon,
>
> On Mon, Jun 19, 2017 at 11:11:31AM -0600, Simon Glass wrote:
>> Move this board over to driver model for MMC and SATA. This means that it
>> uses CONFIG_BLK as well. In SPL these options remain turned off since it
>> increases the code size. One option would be to use CONFIG_SPL_OF_PLATDATA
>> to avoid device-tree overhead.
>>
>> Signed-off-by: Simon Glass <sjg at chromium.org>
>> ---
>>
>>  arch/arm/dts/sun7i-a20-pcduino3.dts   | 1 -
>>  configs/Linksprite_pcDuino3_defconfig | 7 ++++++-
>>  2 files changed, 6 insertions(+), 2 deletions(-)
>>
>> diff --git a/arch/arm/dts/sun7i-a20-pcduino3.dts b/arch/arm/dts/sun7i-a20-pcduino3.dts
>> index 1a8b39be1d..d487c84562 100644
>> --- a/arch/arm/dts/sun7i-a20-pcduino3.dts
>> +++ b/arch/arm/dts/sun7i-a20-pcduino3.dts
>> @@ -164,7 +164,6 @@
>>       pinctrl-0 = <&mmc0_pins_a>, <&mmc0_cd_pin_reference_design>;
>>       vmmc-supply = <&reg_vcc3v3>;
>>       bus-width = <4>;
>> -     cd-gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>; /* PH1 */
>
> Why is this change needed ? Is that the wrong GPIO? Should that be
> submitted to Linux too?

I meant to ask about that in the commit message.

For me this does not work. Maybe there is something wrong with my
board. Are you able to test it?

Regards,
Simon