[U-Boot] [PATCH v2 14/18] sunxi: Pine64: defconfig: enable SPL FIT support

[Andre Przywara]

The Pine64 (and all other 64-bit Allwinner boards) need to load an
ARM Trusted Firmware image beside the actual U-Boot proper.
This can now be easily achieved by using the just extended SPL FIT
loading support, so enable it in the Pine64 defconfig.
Also add the FIT image as a build target to 64-bit sunxi board to
trigger the respective Makefile rules.

Signed-off-by: Andre Przywara <andre.przywara at arm.com>
---
 configs/pine64_plus_defconfig  | 6 ++++++
 include/configs/sunxi-common.h | 4 ++++
 2 files changed, 10 insertions(+)

diff --git a/configs/pine64_plus_defconfig b/configs/pine64_plus_defconfig
index 92bda60..8a90579 100644
--- a/configs/pine64_plus_defconfig
+++ b/configs/pine64_plus_defconfig
@@ -3,9 +3,14 @@ CONFIG_ARCH_SUNXI=y
 CONFIG_MACH_SUN50I=y
 CONFIG_RESERVE_ALLWINNER_BOOT0_HEADER=y
 CONFIG_DEFAULT_DEVICE_TREE="sun50i-a64-pine64-plus"
+CONFIG_OF_LIST="sun50i-a64-pine64 sun50i-a64-pine64-plus"
 # CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
 CONFIG_CONSOLE_MUX=y
 CONFIG_SPL=y
+CONFIG_FIT=y
+CONFIG_SPL_FIT=y
+CONFIG_SPL_LOAD_FIT=y
+CONFIG_SPL_OF_LIBFDT=y
 # CONFIG_CMD_IMLS is not set
 # CONFIG_CMD_FLASH is not set
 # CONFIG_CMD_FPGA is not set
@@ -14,3 +19,4 @@ CONFIG_SPL=y
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_SUN8I_EMAC=y
 CONFIG_USB_EHCI_HCD=y
+CONFIG_SPL_FIT_GENERATOR="board/sunxi/mksunxi_fit_atf.sh"
diff --git a/include/configs/sunxi-common.h b/include/configs/sunxi-common.h
index b7eb95e..1982063 100644
--- a/include/configs/sunxi-common.h
+++ b/include/configs/sunxi-common.h
@@ -32,6 +32,10 @@
 # define CONFIG_MACH_TYPE_COMPAT_REV	1
 #endif
 
+#ifdef CONFIG_ARM64
+#define CONFIG_BUILD_TARGET "u-boot.itb"
+#endif
+
 /* Serial & console */
 #define CONFIG_SYS_NS16550_SERIAL
 /* ns16550 reg in the low bits of cpu reg */
-- 
2.8.2