[U-Boot] [PATCH v3 8/8] rockchip: defconfig: puma-rk3399: update defconfig with video-support

[Philipp Tomsich]

With HDMI output for the RK3399 working, this update the RK3399-Q7
(Puma) defconfig for the new functionality:
1. enables PMIC command (to check if the HDMI voltages are correct)
      +CONFIG_CMD_PMIC=y
      +CONFIG_CMD_REGULATOR=y
2. enables video-output (via HDMI)
      +CONFIG_DM_VIDEO=y
      +CONFIG_DISPLAY=y
      +CONFIG_VIDEO_ROCKCHIP=y
      +CONFIG_DISPLAY_ROCKCHIP_HDMI=y
3. turns on the 'dcache'-command (for a dcache flush) for our QA to
   fill the framebuffer using 'mw.l'
      +CONFIG_CMD_CACHE=y
4. turns on the 'bmp'-command
      +CONFIG_CMD_BMP=y

Signed-off-by: Philipp Tomsich <philipp.tomsich at theobroma-systems.com>

---

Changes in v3: None
Changes in v2:
- enable CMD_BMP in the puma-rk3399_defconfig (following a rebase to
  the upstream master after CMD_BMP was migrate to Kconfig)

 configs/puma-rk3399_defconfig | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/configs/puma-rk3399_defconfig b/configs/puma-rk3399_defconfig
index 33faf1f..b3c30a3 100644
--- a/configs/puma-rk3399_defconfig
+++ b/configs/puma-rk3399_defconfig
@@ -27,7 +27,11 @@ CONFIG_CMD_SPI=y
 CONFIG_CMD_USB=y
 CONFIG_CMD_USB_MASS_STORAGE=y
 # CONFIG_CMD_SETEXPR is not set
+CONFIG_CMD_BMP=y
+CONFIG_CMD_CACHE=y
 CONFIG_CMD_TIME=y
+CONFIG_CMD_PMIC=y
+CONFIG_CMD_REGULATOR=y
 CONFIG_SPL_OF_CONTROL=y
 CONFIG_OF_SPL_REMOVE_PROPS="pinctrl-0 pinctrl-names clock-names interrupt-parent assigned-clocks assigned-clock-rates assigned-clock-parents"
 CONFIG_REGMAP=y
@@ -82,4 +86,8 @@ CONFIG_USB_GADGET_DOWNLOAD=y
 CONFIG_G_DNL_MANUFACTURER="Theobroma Systems"
 CONFIG_G_DNL_VENDOR_NUM=0x2294
 CONFIG_G_DNL_PRODUCT_NUM=0x3399
+CONFIG_DM_VIDEO=y
+CONFIG_DISPLAY=y
+CONFIG_VIDEO_ROCKCHIP=y
+CONFIG_DISPLAY_ROCKCHIP_HDMI=y
 CONFIG_ERRNO_STR=y
-- 
1.9.1