[U-Boot] [PATCH v2 14/30] ks2_evm: Add EEPROM based board detection
Franklin S Cooper Jr
fcooper at ti.com
Tue May 23 17:42:43 UTC 2017
Some K2G evms have their EEPROM programming while most do not. Therefore,
add EEPROM board detection to be used as the default method and fall back
to the alternative board detection when needed.
Also reorder board configuration. Perform bare minimal configuration
initially since board detection hasn't ran. Finish board configuration
once the board has been identified.
Signed-off-by: Franklin S Cooper Jr <fcooper at ti.com>
Reviewed-by: Tom Rini <trini at konsulko.com>
---
board/ti/ks2_evm/board.h | 1 +
board/ti/ks2_evm/board_k2g.c | 44 +++++++++++++++++++++++---------------------
2 files changed, 24 insertions(+), 21 deletions(-)
diff --git a/board/ti/ks2_evm/board.h b/board/ti/ks2_evm/board.h
index 2bbd792..0698921 100644
--- a/board/ti/ks2_evm/board.h
+++ b/board/ti/ks2_evm/board.h
@@ -11,6 +11,7 @@
#define _KS2_BOARD
#include <asm/ti-common/keystone_net.h>
+#include "../common/board_detect.h"
extern struct eth_priv_t eth_priv_cfg[];
diff --git a/board/ti/ks2_evm/board_k2g.c b/board/ti/ks2_evm/board_k2g.c
index d354415..d796fd1 100644
--- a/board/ti/ks2_evm/board_k2g.c
+++ b/board/ti/ks2_evm/board_k2g.c
@@ -246,24 +246,6 @@ static int k2g_alt_board_detect(void)
return 0;
}
-int embedded_dtb_select(void)
-{
- int rc;
-
- rc = k2g_alt_board_detect();
- if (rc) {
- printf("Unable to do board detection\n");
- return -1;
- }
-
- fdtdec_setup();
-
- return 0;
-}
-#endif
-
-#ifdef CONFIG_BOARD_EARLY_INIT_F
-
static void k2g_reset_mux_config(void)
{
/* Unlock the reset mux register */
@@ -277,11 +259,20 @@ static void k2g_reset_mux_config(void)
setbits_le32(KS2_RSTMUX8, RSTMUX_LOCK8_MASK);
}
-int board_early_init_f(void)
+int embedded_dtb_select(void)
{
- init_plls();
+ int rc;
+ rc = ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
+ CONFIG_EEPROM_CHIP_ADDRESS);
+ if (rc) {
+ rc = k2g_alt_board_detect();
+ if (rc) {
+ printf("Unable to do board detection\n");
+ return -1;
+ }
+ }
- k2g_mux_config();
+ fdtdec_setup();
k2g_reset_mux_config();
@@ -313,6 +304,17 @@ int board_late_init(void)
}
#endif
+#ifdef CONFIG_BOARD_EARLY_INIT_F
+int board_early_init_f(void)
+{
+ init_plls();
+
+ k2g_mux_config();
+
+ return 0;
+}
+#endif
+
#ifdef CONFIG_SPL_BUILD
void spl_init_keystone_plls(void)
{
--
2.10.0
More information about the U-Boot
mailing list