[U-Boot] [PATCH 4/4] mx25pdk: Set the eSDHC PER clock to 48 MHz

[Stefano Babic]

On 03/05/2017 11:59, Benoît Thébaudeau wrote:
> The maximum SD clock frequency in High Speed mode is 50 MHz. This change
> makes it possible to get 48 MHz from the USB PLL (240 MHz / 5 / 1)
> instead of the previous 33.25 MHz from the AHB clock (133 MHz / 2 / 2).
> 
> Signed-off-by: Benoît Thébaudeau <benoit at wsystem.com>
> ---
>  board/freescale/mx25pdk/mx25pdk.c | 6 ++++++
>  1 file changed, 6 insertions(+)
> 
> diff --git a/board/freescale/mx25pdk/mx25pdk.c b/board/freescale/mx25pdk/mx25pdk.c
> index 788d3c3..cab769c 100644
> --- a/board/freescale/mx25pdk/mx25pdk.c
> +++ b/board/freescale/mx25pdk/mx25pdk.c
> @@ -175,6 +175,12 @@ int board_mmc_init(bd_t *bis)
>  
>  	imx_iomux_v3_setup_multiple_pads(sdhc1_pads, ARRAY_SIZE(sdhc1_pads));
>  
> +	/*
> +	 * Set the eSDHC1 PER clock to the maximum frequency lower than or equal
> +	 * to 50 MHz that can be obtained, which requires to use UPLL as the
> +	 * clock source. This actually gives 48 MHz.
> +	 */
> +	imx_set_perclk(MXC_ESDHC1_CLK, true, 50000000);
>  	esdhc_cfg[0].sdhc_clk = mxc_get_clock(MXC_ESDHC1_CLK);
>  	return fsl_esdhc_initialize(bis, &esdhc_cfg[0]);
>  }
> 

Applied to u-boot-imx -master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================