[U-Boot] [PATCH] armv8: ls1088aqds: Change phy mode to PHY_INTERFACE_MODE_RGMII_ID

[Ashish Kumar]

Since TX delay is now enabled only in PHY_INTERFACE_MODE_RGMII_ID
PHY_INTERFACE_MODE_RGMII_TXID.

These change where introduced in phy driver in commit titled
"net: phy: realtek: fix enabling of the TX-delay for RTL8211F"

Signed-off-by: Ashish Kumar <Ashish.Kumar at nxp.com>
---
 board/freescale/ls1088a/eth_ls1088aqds.c | 1 +
 drivers/net/ldpaa_eth/ls1088a.c          | 4 ++--
 2 files changed, 3 insertions(+), 2 deletions(-)

diff --git a/board/freescale/ls1088a/eth_ls1088aqds.c b/board/freescale/ls1088a/eth_ls1088aqds.c
index f5320eb..f056fde 100644
--- a/board/freescale/ls1088a/eth_ls1088aqds.c
+++ b/board/freescale/ls1088a/eth_ls1088aqds.c
@@ -637,6 +637,7 @@ int board_eth_init(bd_t *bis)
 	for (i = WRIOP1_DPMAC1; i < NUM_WRIOP_PORTS; i++) {
 		switch (wriop_get_enet_if(i)) {
 		case PHY_INTERFACE_MODE_RGMII:
+		case PHY_INTERFACE_MODE_RGMII_ID:
 			ls1088a_handle_phy_interface_rgmii(i);
 			break;
 		case PHY_INTERFACE_MODE_QSGMII:
diff --git a/drivers/net/ldpaa_eth/ls1088a.c b/drivers/net/ldpaa_eth/ls1088a.c
index 061935e..780a239 100644
--- a/drivers/net/ldpaa_eth/ls1088a.c
+++ b/drivers/net/ldpaa_eth/ls1088a.c
@@ -99,7 +99,7 @@ void fsl_rgmii_init(void)
 	ec >>= FSL_CHASSIS3_RCWSR25_EC1_PRTCL_SHIFT;
 
 	if (!ec)
-		wriop_init_dpmac_enet_if(4, PHY_INTERFACE_MODE_RGMII);
+		wriop_init_dpmac_enet_if(4, PHY_INTERFACE_MODE_RGMII_ID);
 #endif
 
 #ifdef CONFIG_SYS_FSL_EC2
@@ -108,7 +108,7 @@ void fsl_rgmii_init(void)
 	ec >>= FSL_CHASSIS3_RCWSR25_EC2_PRTCL_SHIFT;
 
 	if (!ec)
-		wriop_init_dpmac_enet_if(5, PHY_INTERFACE_MODE_RGMII);
+		wriop_init_dpmac_enet_if(5, PHY_INTERFACE_MODE_RGMII_ID);
 #endif
 }
 #endif
-- 
2.7.4