[U-Boot] [PATCH 0/4] net: phy: Add Broadcom BCM53xx switch driver

[Florian Fainelli]

(this time after subscribing to the list)

Hi all,

This patch series adds support for the Broadcom BCM53xx switches, in particular
BCM53125 which is found no the Lamobo R1 board.

The driver is largely based on the DSA/b53 driver Linux driver and only
incorporates what is necessary to succesfully bring-up all ports (including the
management port) for boot over the network:

=> dhcp
dw_adjust_link: Speed: 1000, full duplex
BOOTP broadcast 1
DHCP client bound to address 192.168.0.11 (3 ms)
Using ethernet at 01c50000 device
TFTP from server 192.168.0.1; our IP address is 192.168.0.11
Filename 'sun7i-a20-lamobo-r1-kernel.bin'.
Load address: 0x42000000
Loading: #################################################################
         #################################################################
         ################################
         11.6 MiB/s
done
Bytes transferred = 2371552 (242fe0 hex)
=> 


Florian Fainelli (4):
  net: phy: Add Broadcom BCM53xx switch driver
  net: designware: Pad small packets
  net: phy: b53: Add b53_reg read/write commands
  configs: Update Lamobo_R1 with B53 switch options

 configs/Lamobo_R1_defconfig |   3 +
 drivers/net/designware.c    |   4 +
 drivers/net/phy/Kconfig     |  14 +
 drivers/net/phy/Makefile    |   1 +
 drivers/net/phy/b53.c       | 767 ++++++++++++++++++++++++++++++++++++++++++++
 drivers/net/phy/phy.c       |   3 +
 include/phy.h               |   1 +
 7 files changed, 793 insertions(+)
 create mode 100644 drivers/net/phy/b53.c

-- 
2.11.0