[U-Boot] [PATCH] mmc: replace the printf() instead of error()

[Jaehoon Chung]

On 10/23/2017 01:46 PM, Jaehoon Chung wrote:
> Replace the printf() instead of error().
> It is occurred the compiler error with "undefined reference to 'error'".
> 
> Fixes: e0079fecd75b ("mmc: refacstor SD startup to make it easier to support new modes")
> 
> Signed-off-by: Jaehoon Chung <jh80.chung at samsung.com>

Applied to u-boot-mmc.

Best Regards,
Jaehoon Chung

> ---
>  drivers/mmc/mmc.c | 8 ++++----
>  1 file changed, 4 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c
> index 55a53c2200..a5a521eec3 100644
> --- a/drivers/mmc/mmc.c
> +++ b/drivers/mmc/mmc.c
> @@ -828,7 +828,7 @@ static int mmc_get_capabilities(struct mmc *mmc)
>  		return 0;
>  
>  	if (!ext_csd) {
> -		error("No ext_csd found!\n"); /* this should enver happen */
> +		printf("No ext_csd found!\n"); /* this should enver happen */
>  		return -ENOTSUPP;
>  	}
>  
> @@ -1433,7 +1433,7 @@ static inline int bus_width(uint cap)
>  		return 4;
>  	if (cap == MMC_MODE_1BIT)
>  		return 1;
> -	error("invalid bus witdh capability 0x%x\n", cap);
> +	printf("invalid bus witdh capability 0x%x\n", cap);
>  	return 0;
>  }
>  
> @@ -1638,7 +1638,7 @@ error:
>  		}
>  	}
>  
> -	error("unable to select a mode\n");
> +	printf("unable to select a mode\n");
>  	return -ENOTSUPP;
>  }
>  
> @@ -1844,7 +1844,7 @@ error:
>  		}
>  	}
>  
> -	error("unable to select a mode\n");
> +	printf("unable to select a mode\n");
>  
>  	return -ENOTSUPP;
>  }
>