[U-Boot] [PATCH] arm64: xilinx: Setup default number of chipselects for zcu100

[Michal Simek]

There is only one chipselect on each connector.
Define it directly in board dts file.
There should be an option to use more chipselects via gpios.

Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 arch/arm/dts/zynqmp-zcu100-revC.dts | 2 ++
 1 file changed, 2 insertions(+)

diff --git a/arch/arm/dts/zynqmp-zcu100-revC.dts b/arch/arm/dts/zynqmp-zcu100-revC.dts
index 6e575a063bef..2fffe177b589 100644
--- a/arch/arm/dts/zynqmp-zcu100-revC.dts
+++ b/arch/arm/dts/zynqmp-zcu100-revC.dts
@@ -280,11 +280,13 @@
 &spi0 { /* Low Speed connector */
 	status = "okay";
 	label = "LS-SPI0";
+	num-cs = <1>;
 };
 
 &spi1 { /* High Speed connector */
 	status = "okay";
 	label = "HS-SPI1";
+	num-cs = <1>;
 };
 
 &uart0 {
-- 
1.9.1