[U-Boot] [PATCH 0/6] mx6cuboxi: Add support for SOMs with eMMC

[Stefano Babic]

On 11/06/2018 14:26, Baruch Siach wrote:
> The newer rev 1.5 of the SolidRun i.MX6 SOM can optionally come with eMMC on
> the SOM. This series adds support for the eMMC device on these SOMs.
> 
> Since eMMC has card detect signal this series uses the new mmc_get_op_cond()
> function that is broken out of mmc_init_start(). Successful completion of
> mmc_get_op_cond() indicates that the eMMC is present.
> 
> Finally, the last patch in this series constructs the name of the kernel
> device tree to load. This name is compatible with recent mainline kernels.
> 
> This series depends on the patches adding support for SOM rev 1.5 that were
> posted earlier:
> 
>   https://patchwork.ozlabs.org/patch/926302/
>   https://patchwork.ozlabs.org/patch/926301/
> 
> Baruch Siach (2):
>   mmc: drop mention of IN_PROGRESS status
>   mx6cuboxi: drop CONFIG_SYS_FSL_USDHC_NUM
> 
> Jon Nettleton (4):
>   mmc: break out get_op_cond code to its own function
>   mx6cuboxi: Add support for eMMC booting
>   mx6cuboxi: Use mmc_get_op_cond() to check for an eMMC
>   mx6cuboxi: Add emmc device tree suffix
> 
>  board/solidrun/mx6cuboxi/mx6cuboxi.c | 115 +++++++++++++++++++++++++--
>  drivers/mmc/mmc.c                    |  61 ++++++++------
>  include/configs/mx6cuboxi.h          |  25 +++---
>  include/mmc.h                        |  12 ++-
>  4 files changed, 167 insertions(+), 46 deletions(-)
> 

Applied to u-boot-imx, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================