[U-Boot] [PULL] Please pull u-boot-imx
Stefano Babic
sbabic at denx.de
Mon Jul 23 09:44:04 UTC 2018
Hi Tom,
please pull from u-boot-imx, thanks !
The following changes since commit 474ecd2c84d97314b8145fbe3a57887f41b2edb3:
env: Simplify Makefile using $(SPL_TPL_) (2018-07-21 12:24:31 -0400)
are available in the git repository at:
git://www.denx.de/git/u-boot-imx.git master
for you to fetch changes up to f97f167107b33fc6596561dae1309571ade39055:
configs: imx6q_logic: Cleanup ramdiskaddr and fdtaddr (2018-07-23
11:05:54 +0200)
----------------------------------------------------------------
Adam Ford (2):
imx: i.mx6q: imx6q_logic: Migrate to SPL and enable SDP
configs: imx6q_logic: Cleanup ramdiskaddr and fdtaddr
Baruch Siach (2):
mmc: drop mention of IN_PROGRESS status
mx6cuboxi: drop CONFIG_SYS_FSL_USDHC_NUM
Fabio Berton (1):
pico-imx7d: Add support for update SPL using DFU
Fabio Estevam (7):
mx7: Remove BMODE support
pico-imx7d: Convert to distro config
pico-imx7d: Add fastboot support
pico-imx7d: Add SPL support
pico-imx7d: Add Falcon mode support
pico-imx7d: Enable CONFIG_ARMV7_BOOT_SEC_DEFAULT
pico-imx7d: Do not override addrmap5
Holger Dengler (1):
tools/imximage: get HAB information from header
Jon Nettleton (5):
mmc: break out get_op_cond code to its own function
mx6cuboxi: Add support for eMMC booting
mx6cuboxi: Use mmc_get_op_cond() to check for an eMMC
mx6cuboxi: Add emmc device tree suffix
mx6cuboxi: Move the default environment for all devices
Ludwig Zenz (4):
Revert "ARM: imx6: Disable DDR DRAM calibration DHCOM i.MX6 PDK"
ARM: imx6: configure ddrcode pins in spl DHCOM i.MX6 PDK
ARM: imx6: DHCOM i.MX6 PDK: ddr init for 32bit bus and 4GBit chips
ARM: dh_imx6: enable GigaDevice, Macronix, and Winbond SPI Flash
support in Kconfig
Mark Jonas (1):
arm, imx6: add alternative PAD_CTL_DSE constants
Martin Kaiser (1):
mx25: fix the offset between the USB ports' registers
Michael Trimarchi (4):
eth: dm: fec: Add gpio phy reset binding
imx: mx6: Fix implementantion reset_misc
imx: imx6: Add comment to gpr_init function
i.MX6: engicam: gpr_init can be called only for some architecture
Otavio Salvador (9):
pico-imx7d: Fix common distro configuration behavior
pico-imx7d: Add GPT partitioning support
pico-imx7d: Add default DFU targets
pico-imx7d: Add bootmenu to choose the baseboard
pico-imx7d: Allow default fdtfile to be overridden by defconfig
pico-imx7d: Enable auxiliary code support
pico-imx7d: README: Use dfu-util to flash U-Boot
pico-imx7d: README: Drop old instructions about secure mode
pico-imx7d: Add new pico-pi config
Stefan Agner (12):
mtd: nand: mxs_nand: add device tree support for i.MX 6
imx: add macro to detect whether USB has been initialized
ARM: dts: imx6ull: use same compatible string as Linux is using
board: toradex: add new and upcoming SKUs
board: toradex: add Colibri iMX6ULL support
ARM: PSCI: initialize stack pointer on secondary CPUs
imx: mx7: psci: use C code exclusively
imx: mx7: psci: provide complete PSCI 1.0 implementation
imx: mx7: psci: support CPU0 on/off
imx: mx7: psci: implement MIGRATE_INFO_TYPE
colibri_imx7: add compatible string used in vanilla Linux
colibri_imx7: improve DDR3 timing
Stefano Babic (1):
bootcount: flush after storing the bootcounter
Uri Mashiach (1):
arm: imx7d: cl-som-imx7: sf: support all SF types
arch/arm/cpu/armv7/psci.S | 2 +
arch/arm/dts/imx6ull-colibri.dts | 550
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
arch/arm/dts/imx6ull.dtsi | 2 +-
arch/arm/include/asm/arch-mx25/imx-regs.h | 7 +-
arch/arm/include/asm/arch-mx6/imx-regs.h | 7 ++
arch/arm/include/asm/mach-imx/iomux-v3.h | 8 +++
arch/arm/mach-imx/Kconfig | 2 +-
arch/arm/mach-imx/mx6/Kconfig | 11 ++-
arch/arm/mach-imx/mx6/soc.c | 7 ++
arch/arm/mach-imx/mx7/Kconfig | 2 +-
arch/arm/mach-imx/mx7/Makefile | 5 +-
arch/arm/mach-imx/mx7/psci-mx7.c | 148
++++++++++++++++++++++++++++++++++++----
arch/arm/mach-imx/mx7/psci.S | 60 ----------------
arch/arm/mach-imx/mx7/soc.c | 25 -------
board/dhelectronics/dh_imx6/dh_imx6_spl.c | 227
++++++++++++++++++++++++++++++++++++++++++++++++++++++++----
board/engicam/common/spl.c | 3 +-
board/logicpd/imx6/imx6logic.c | 141
++++++++++++++++++++++++++++++++++++++
board/logicpd/imx6/mx6q_2x_MT41K512M16HA.cfg | 111
------------------------------
board/solidrun/mx6cuboxi/mx6cuboxi.c | 115
++++++++++++++++++++++++++++---
board/technexion/pico-imx7d/Makefile | 2 +-
board/technexion/pico-imx7d/README | 30 +++-----
board/technexion/pico-imx7d/imximage.cfg | 97
--------------------------
board/technexion/pico-imx7d/pico-imx7d.c | 2 +-
board/technexion/pico-imx7d/spl.c | 122
+++++++++++++++++++++++++++++++++
board/toradex/colibri-imx6ull/Kconfig | 29 ++++++++
board/toradex/colibri-imx6ull/MAINTAINERS | 10 +++
board/toradex/colibri-imx6ull/Makefile | 4 ++
board/toradex/colibri-imx6ull/colibri-imx6ull.c | 408
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
board/toradex/colibri-imx6ull/imximage.cfg | 106
++++++++++++++++++++++++++++
board/toradex/colibri_imx7/colibri_imx7.c | 20 +-----
board/toradex/colibri_imx7/imximage.cfg | 10 +--
board/toradex/common/tdx-cfg-block.c | 7 ++
board/toradex/common/tdx-cfg-block.h | 7 ++
configs/cl-som-imx7_defconfig | 7 ++
configs/colibri-imx6ull_defconfig | 76 +++++++++++++++++++++
configs/dh_imx6_defconfig | 3 +
configs/imx6q_logic_defconfig | 47 +++++++++++--
configs/pico-imx7d_defconfig | 41 ++++++++---
configs/pico-pi-imx7d_defconfig | 59 ++++++++++++++++
drivers/bootcount/bootcount.c | 3 +
drivers/mmc/mmc.c | 61 ++++++++++-------
drivers/mtd/nand/mxs_nand_dt.c | 8 +++
drivers/net/fec_mxc.c | 43 ++++++++++--
drivers/net/fec_mxc.h | 5 +-
include/configs/colibri-imx6ull.h | 199
+++++++++++++++++++++++++++++++++++++++++++++++++++++
include/configs/imx6_logic.h | 46 +++++++++----
include/configs/mx6cuboxi.h | 27 ++++----
include/configs/pico-imx7d.h | 94
+++++++++++++------------
include/mmc.h | 12 +++-
tools/imximage.c | 13 ++--
50 files changed, 2523 insertions(+), 508 deletions(-)
create mode 100644 arch/arm/dts/imx6ull-colibri.dts
delete mode 100644 arch/arm/mach-imx/mx7/psci.S
delete mode 100644 board/logicpd/imx6/mx6q_2x_MT41K512M16HA.cfg
delete mode 100644 board/technexion/pico-imx7d/imximage.cfg
create mode 100644 board/technexion/pico-imx7d/spl.c
create mode 100644 board/toradex/colibri-imx6ull/Kconfig
create mode 100644 board/toradex/colibri-imx6ull/MAINTAINERS
create mode 100644 board/toradex/colibri-imx6ull/Makefile
create mode 100644 board/toradex/colibri-imx6ull/colibri-imx6ull.c
create mode 100644 board/toradex/colibri-imx6ull/imximage.cfg
create mode 100644 configs/colibri-imx6ull_defconfig
create mode 100644 configs/pico-pi-imx7d_defconfig
create mode 100644 include/configs/colibri-imx6ull.h
--
=====================================================================
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================
More information about the U-Boot
mailing list