[U-Boot] [PATCH 3/4] gpio: xilinx: Set value before changing direction

[Michal Simek]

Set a value before changing gpio direction. This will ensure that the
old value is not propagated when direction has changed but new value is
not written yet.

Reported-by: Stefan Herbrechtsmeier <stefan at herbrechtsmeier.net>
Signed-off-by: Michal Simek <michal.simek at xilinx.com>
---

 drivers/gpio/xilinx_gpio.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/xilinx_gpio.c b/drivers/gpio/xilinx_gpio.c
index 776a147cc8d7..1e5f3da8d7e8 100644
--- a/drivers/gpio/xilinx_gpio.c
+++ b/drivers/gpio/xilinx_gpio.c
@@ -139,14 +139,14 @@ static int xilinx_gpio_direction_output(struct udevice *dev, unsigned offset,
 	if (platdata->bank_input[bank])
 		return -EINVAL;
 
+	xilinx_gpio_set_value(dev, offset, value);
+
 	if (!platdata->bank_output[bank]) {
 		val = readl(&platdata->regs->gpiodir + bank * 2);
 		val = val & ~(1 << pin);
 		writel(val, &platdata->regs->gpiodir + bank * 2);
 	}
 
-	xilinx_gpio_set_value(dev, offset, value);
-
 	return 0;
 }
 
-- 
1.9.1