[U-Boot] [linux-sunxi] [PATCH v2 00/13] Allwinner H6 support (w/ SPL)

[Jagan Teki]

On Tue, Jul 31, 2018 at 11:15 AM, Icenowy Zheng <icenowy at aosc.io> wrote:
>
>
> 于 2018年7月31日 GMT+08:00 下午1:42:46, Jagan Teki <jagan at amarulasolutions.com> 写到:
>>On Sun, Jul 29, 2018 at 6:54 PM, Icenowy Zheng <icenowy at aosc.io> wrote:
>>> 在 2018-07-27五的 18:48 +0530，Jagan Teki写道：
>>>> On Thu, Jul 26, 2018 at 12:35 PM, Icenowy Zheng <icenowy at aosc.io>
>>>> wrote:
>>>> >
>>>> >
>>>> > 于 2018年7月26日 GMT+08:00 下午3:02:50, Jagan Teki <
>>>> > jagan at amarulasolutions.com> 写到:
>>>> > > On Sat, Jul 21, 2018 at 1:50 PM, Icenowy Zheng <icenowy at aosc.io>
>>>> > > wrote:
>>>> > > > This patchset trys to add support for Allwinner H6 SoC to U-
>>>> > > > Boot.
>>>> > > >
>>>> > > > Allwinner H6 is a quite new Allwinner SoC, with several parts
>>>> > > > changed
>>>> > >
>>>> > > a
>>>> > > > lot (memory map, DRAM controller, CCU, so on). The position
>>>> > > > which SPL
>>>> > > > will be loaded (SRAM A1) also changed to 0x20000.
>>>> > > >
>>>> > > > The Pine H64 board support comes with this patchset, as this
>>is
>>>> > > > the
>>>> > > > first H6 board that I can get (being early bird).
>>>> > > >
>>>> > > > Icenowy Zheng (13):
>>>> > > >   sunxi: change SUNXI_HIGH_SRAM option to SUNXI_SRAM_ADDRESS
>>>> > > >   sunxi: add basic memory map definitions of H6 SoC
>>>> > > >   sunxi: change RMR64's RVBAR address for H6
>>>> > > >   sunxi: change ATF position for H6
>>>> > > >   sunxi: add config for SPL at 0x20000 on H6
>>>> > > >   sunxi: change GIC address on H6
>>>> > > >   sunxi: add clock code for H6
>>>> > > >   sunxi: use sun6i-style watchdog for H6
>>>> > > >   sunxi: add UART0 setup for H6
>>>> > > >   sunxi: add MMC support for H6
>>>> > > >   sunxi: add DRAM support to H6
>>>> > > >   sunxi: add support for Allwinner H6 SoC
>>>> > > >   sunxi: add support for Pine H64 board
>>>>
>>>> Reviewed-by: Jagan Teki <jagan at openedev.com>
>>>
>>> Do you consider merge it now?
>>
>>Yes, but there is a comment about kconfig move [1], I'm OK to send the
>>change later since it can effect all SoC.
>
> Yes I suppose so.

Thanks.

>
> Also apply for the DM MMC change.

Which change, can you point?

>
> BTW Are you working on some DM clock driver?

Yes.