[U-Boot] [PATCH] sf: Set current flash bank to 0 in clean_bar()

[Marek Vasut]

On 06/04/2018 08:03 PM, Jagan Teki wrote:
> On Fri, May 25, 2018 at 1:28 AM, Marek Vasut <marex at denx.de> wrote:
>> The clean_bar() function resets the SPI NOR BAR register to 0, but
>> does not set the flash->curr_bar to 0 , therefore those two can get
>> out of sync, which could ultimatelly result in corrupted flash content.
>>
>> The simplest test case is this:
>>
>>   => mw 0x10000000 0x1234abcd 0x4000
>>   => sf probe
>>   => sf erase 0x1000000 0x10000
>>   => sf write 0x10000000 0x1000000 0x10000
>>
>>   => sf probe ; sf read 0x12000000 0 0x10000 ; md 0x12000000
>>
>> That is, erase a sector above the 16 MiB boundary and write it with
>> random pre-configured data. What will actually happen without this
>> patch is the sector will be erased, but the data will be written to
>> BAR 0 offset 0x0 in the flash.
>>
>> This is because the erase command will call write_bar()+clean_bar(),
>> which will leave flash->bank_curr = 1 while the hardware BAR registers
>> will be set to 0 through clean_bar(). The subsequent write will also
>> trigger write_bar()+clean_bar(), but write_bar checks if the target
>> bank == flash->bank_curr and if so, does NOT reconfigure the BAR in
>> the SPI NOR. Since flash->bank_curr is still 1 and out of sync with
>> the HW, the condition matches, BAR programming is skipped and write
>> ends up at address 0x0, thus corrupting flash content.
>>
>> Signed-off-by: Marek Vasut <marex at denx.de>
>> Cc: Jagan Teki <jagan at openedev.com>
>> Cc: Tom Rini <trini at konsulko.com>
> 
> Reviewed-by: Jagan Teki <jagan at openedev.com>
> 
> Applied to u-boot-spi/master

So I presume you see it now ?

-- 
Best regards,
Marek Vasut