[U-Boot] [PATCH 07/18] dm: pci: Use a 1:1 mapping for bus <-> phy addresses

[Bin Meng]

From: Christian Gmeiner <christian.gmeiner at gmail.com>

If U-Boot gets used as coreboot payload all pci resources got
assigned by coreboot. If a dts without any pci ranges gets used
the dm is not able to access pci device memory. To get things
working make use of a 1:1 mapping for bus <-> phy addresses.

This change makes it possible to get the e1000 U-Boot driver
working on a sandybridge device where U-Boot is used as coreboot
payload.

Signed-off-by: Christian Gmeiner <christian.gmeiner at gmail.com>
Reviewed-by: Bin Meng <bmeng.cn at gmail.com>
[bmeng: fixed 'u-boot' in the commit message]
Signed-off-by: Bin Meng <bmeng.cn at gmail.com>

---

 drivers/pci/pci-uclass.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/drivers/pci/pci-uclass.c b/drivers/pci/pci-uclass.c
index de4c71b..46e9c71 100644
--- a/drivers/pci/pci-uclass.c
+++ b/drivers/pci/pci-uclass.c
@@ -1182,6 +1182,11 @@ static int _dm_pci_bus_to_phys(struct udevice *ctlr,
 	struct pci_region *res;
 	int i;
 
+	if (hose->region_count == 0) {
+		*pa = bus_addr;
+		return 0;
+	}
+
 	for (i = 0; i < hose->region_count; i++) {
 		res = &hose->regions[i];
 
@@ -1245,6 +1250,11 @@ int _dm_pci_phys_to_bus(struct udevice *dev, phys_addr_t phys_addr,
 	ctlr = pci_get_controller(dev);
 	hose = dev_get_uclass_priv(ctlr);
 
+	if (hose->region_count == 0) {
+		*ba = phys_addr;
+		return 0;
+	}
+
 	for (i = 0; i < hose->region_count; i++) {
 		res = &hose->regions[i];
 
-- 
2.7.4