[U-Boot] [PATCH 3/3] ARM: dts: rmobile: Move the PHY reset GPIOs into PHY nodes

[Marek Vasut]

Both the RAVB and SH ether driver now support parsing the PHY reset
GPIOs from both the PHY nodes and the MAC nodes, move the reset GPIOs
back into the PHY nodes to minimize DT difference between U-Boot and
Linux.

Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
Cc: Nobuhiro Iwamatsu <iwamatsu at nigauri.org>
---
 arch/arm/dts/r8a77970-eagle.dts   | 2 +-
 arch/arm/dts/salvator-common.dtsi | 2 +-
 2 files changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm/dts/r8a77970-eagle.dts b/arch/arm/dts/r8a77970-eagle.dts
index 5b8b2f8704..5dcad63492 100644
--- a/arch/arm/dts/r8a77970-eagle.dts
+++ b/arch/arm/dts/r8a77970-eagle.dts
@@ -39,13 +39,13 @@
 	phy-handle = <&phy0>;
 	phy-mode = "rgmii-id";
 	status = "okay";
-	reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
 
 	phy0: ethernet-phy at 0 {
 		rxc-skew-ps = <1500>;
 		reg = <0>;
 		interrupt-parent = <&gpio1>;
 		interrupts = <17 IRQ_TYPE_LEVEL_LOW>;
+		reset-gpios = <&gpio1 16 GPIO_ACTIVE_LOW>;
 	};
 };
 
diff --git a/arch/arm/dts/salvator-common.dtsi b/arch/arm/dts/salvator-common.dtsi
index 6b176ea36a..514c57b2c8 100644
--- a/arch/arm/dts/salvator-common.dtsi
+++ b/arch/arm/dts/salvator-common.dtsi
@@ -257,7 +257,6 @@
 	pinctrl-names = "default";
 	phy-handle = <&phy0>;
 	phy-mode = "rgmii-txid";
-	reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
 	status = "okay";
 
 	phy0: ethernet-phy at 0 {
@@ -265,6 +264,7 @@
 		reg = <0>;
 		interrupt-parent = <&gpio2>;
 		interrupts = <11 IRQ_TYPE_LEVEL_LOW>;
+		reset-gpios = <&gpio2 10 GPIO_ACTIVE_LOW>;
 	};
 };
 
-- 
2.17.1