[U-Boot] [PATCH] net: ravb: Filter out supported PHY features

[Marek Vasut]

The RAVB only supports 100Full and 1000Full operation, it does not support
10Full or any Half-duplex modes. The PHY could still advertise those features
though, so filter out the PHY features accordingly.

Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
Cc: Nobuhiro Iwamatsu <iwamatsu at nigauri.org>
Cc: Joe Hershberger <joe.hershberger at ni.com>
---
 drivers/net/ravb.c | 11 ++++++-----
 1 file changed, 6 insertions(+), 5 deletions(-)

diff --git a/drivers/net/ravb.c b/drivers/net/ravb.c
index d66fcef4e7..adcbc931e0 100644
--- a/drivers/net/ravb.c
+++ b/drivers/net/ravb.c
@@ -318,12 +318,13 @@ static int ravb_phy_config(struct udevice *dev)
 
 	eth->phydev = phydev;
 
-	/* 10BASE is not supported for Ethernet AVB MAC */
-	phydev->supported &= ~(SUPPORTED_10baseT_Full
-			       | SUPPORTED_10baseT_Half);
+	phydev->supported &= SUPPORTED_100baseT_Full |
+			     SUPPORTED_1000baseT_Full | SUPPORTED_Autoneg |
+			     SUPPORTED_TP | SUPPORTED_MII | SUPPORTED_Pause |
+			     SUPPORTED_Asym_Pause;
+
 	if (pdata->max_speed != 1000) {
-		phydev->supported &= ~(SUPPORTED_1000baseT_Half
-				       | SUPPORTED_1000baseT_Full);
+		phydev->supported &= ~SUPPORTED_1000baseT_Full;
 		reg = phy_read(phydev, -1, MII_CTRL1000);
 		reg &= ~(BIT(9) | BIT(8));
 		phy_write(phydev, -1, MII_CTRL1000, reg);
-- 
2.17.1