[U-Boot] [PATCH v2] arm, imx6: add alternative PAD_CTL_DSE constants

Mark Jonas mark.jonas at de.bosch.com
Thu Jun 28 08:07:27 UTC 2018


Not all i.MX6 pads use the same drive strength table. So far only the
240 Ohm to 34 Ohm table was available. Because the constants used have
speaking names it can be confusing to use e.g. PAD_CTL_DSE_48ohm when
according to the reference manual 52 Ohm is the correct value. This
patch adds the 260 Ohm to 37 Ohm table.

For example, the IOMUXC_SW_PAD_CTL_PAD_SD2_CLK register (SD-card clock)
uses the added table.

Signed-off-by: Mark Jonas <mark.jonas at de.bosch.com>
---
Changes in V2:
 - Add missing Signed-off-by
---
 arch/arm/include/asm/mach-imx/iomux-v3.h | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/arch/arm/include/asm/mach-imx/iomux-v3.h b/arch/arm/include/asm/mach-imx/iomux-v3.h
index bb93058..63f4b33 100644
--- a/arch/arm/include/asm/mach-imx/iomux-v3.h
+++ b/arch/arm/include/asm/mach-imx/iomux-v3.h
@@ -163,6 +163,14 @@ typedef u64 iomux_v3_cfg_t;
 #define PAD_CTL_DSE_40ohm	(6 << 3)
 #define PAD_CTL_DSE_34ohm	(7 << 3)
 
+#define PAD_CTL_DSE_260ohm	(1 << 3)
+#define PAD_CTL_DSE_130ohm	(2 << 3)
+#define PAD_CTL_DSE_88ohm	(3 << 3)
+#define PAD_CTL_DSE_65ohm	(4 << 3)
+#define PAD_CTL_DSE_52ohm	(5 << 3)
+#define PAD_CTL_DSE_43ohm	(6 << 3)
+#define PAD_CTL_DSE_37ohm	(7 << 3)
+
 /* i.MX6SL/SLL */
 #define PAD_CTL_LVE		(1 << 1)
 #define PAD_CTL_LVE_BIT		(1 << 22)
-- 
2.7.4



More information about the U-Boot mailing list