[U-Boot] [PATCH 2/2] splash: sf: Read default speed and mode values from DT

[Patrick Delaunay]

In case of DT boot, don't read default speed and mode for SPI from
CONFIG_*, instead read from DT node.

Signed-off-by: Patrick Delaunay <patrick.delaunay at st.com>
---

 common/splash_source.c | 8 ++++++++
 1 file changed, 8 insertions(+)

diff --git a/common/splash_source.c b/common/splash_source.c
index 62763b9..f0b3407 100644
--- a/common/splash_source.c
+++ b/common/splash_source.c
@@ -25,10 +25,18 @@ static struct spi_flash *sf;
 static int splash_sf_read_raw(u32 bmp_load_addr, int offset, size_t read_size)
 {
 	if (!sf) {
+#ifdef CONFIG_DM_SPI_FLASH
+		/* In DM mode defaults will be taken from DT */
+		sf = spi_flash_probe(CONFIG_SF_DEFAULT_BUS,
+				     CONFIG_SF_DEFAULT_CS,
+				     0,
+				     0);
+#else
 		sf = spi_flash_probe(CONFIG_SF_DEFAULT_BUS,
 				     CONFIG_SF_DEFAULT_CS,
 				     CONFIG_SF_DEFAULT_SPEED,
 				     CONFIG_SF_DEFAULT_MODE);
+#endif
 		if (!sf)
 			return -ENODEV;
 	}
-- 
2.7.4