[U-Boot] [PATCH v5 0/4] Add support for Pinebook

[Jagan Teki]

On Tue, Nov 6, 2018 at 9:55 AM Vasily Khoruzhick <anarsoul at gmail.com> wrote:
>
> This series adds support for the Pinebook, an allwinner A64 laptop
> produced by Pine64. It also adds support for mmc delay calibration,
> R_I2C controller, and addresses the issue with activating video
> bridge when any of GPIOs is missing.
>
> This series depends on André's "sunxi: A64/H3/H5 DT updates"
>
> v2: - sync sun50i-a64.dtsi with linux instead of adding missing nodes
>     - take sun50i-a64-pinebook.dts from linux
>     - don't introduce new Kconfig for A64 MMC calibration
>     - improve code in video bridge uclass to check for presensce of
>       GPIO instead of ingoring EINVAL errors
> v3: - enable calibration for H6 as well
>     - init ret variable in video_bridge_set_active()
>     - fix order of dts files Makefile
>     - split anx6345 binding into sun50i-a64-pinebook-u-boot.dts
>     - drop speaker_amp node from pinebook dts
>     - drop unnecessary options from defconfig
> v4: - sync device tree files with linux-next
> v5: - drop patch to sync device tree files with linux-next
>
> Vasily Khoruzhick (4):
>   mmc: sunxi: add support for automatic delay calibration
>   dm: video: bridge: don't fail to activate bridge if reset or sleep
>     GPIO is missing
>   sun50i: A64: add support for R_I2C controller
>   sunxi: DT: add support for Pinebook

Applied to u-boot-sunxi/master