[U-Boot] [PATCH 23/34] spi: mpc8xxx: Convert to DM
Jagan Teki
jagan at amarulasolutions.com
Tue Nov 20 12:48:03 UTC 2018
From: Mario Six <mario.six at gdsys.cc>
Support DM in the MPC8xxx SPI driver, and remove the legacy SPI
interface.
Signed-off-by: Mario Six <mario.six at gdsys.cc>
[jagan: build for board which doesn't enable DM_SPI]
Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
---
Makefile | 3 +-
drivers/spi/Makefile | 2 +-
drivers/spi/mpc8xxx_spi.c | 144 ++++++++++++++++++++++++++++----------
drivers/spi/spi.c | 1 +
4 files changed, 111 insertions(+), 39 deletions(-)
diff --git a/Makefile b/Makefile
index efa68e7343..7c1d934493 100644
--- a/Makefile
+++ b/Makefile
@@ -919,7 +919,8 @@ ifeq ($(CONFIG_DM_I2C_COMPAT)$(CONFIG_SANDBOX),y)
@echo "===================================================="
endif
ifeq ($(CONFIG_DM_SPI),)
-ifeq ($(filter $(CONFIG_DAVINCI_SPI) $(CONFIG_KIRKWOOD_SPI) $(CONFIG_TI_QSPI),y),y)
+ifeq ($(filter $(CONFIG_DAVINCI_SPI) $(CONFIG_KIRKWOOD_SPI) $(CONFIG_MPC8XXX_SPI) \
+ $(CONFIG_TI_QSPI),y),y)
@echo "===================== WARNING ======================"
@echo "This board uses SPI driver from drivers/spi/ without"
@echo "enabling CONFIG_DM_SPI. Please enable CONFIG_DM_SPI"
diff --git a/drivers/spi/Makefile b/drivers/spi/Makefile
index 748d9a90ab..19aa95b2ca 100644
--- a/drivers/spi/Makefile
+++ b/drivers/spi/Makefile
@@ -8,6 +8,7 @@ ifdef CONFIG_DM_SPI
obj-y += spi-uclass.o
obj-$(CONFIG_DAVINCI_SPI) += davinci_spi.o
obj-$(CONFIG_KIRKWOOD_SPI) += kirkwood_spi.o
+obj-$(CONFIG_MPC8XXX_SPI) += mpc8xxx_spi.o
obj-$(CONFIG_SANDBOX) += spi-emul-uclass.o
obj-$(CONFIG_SOFT_SPI) += soft_spi.o
obj-$(CONFIG_SPI_MEM) += spi-mem.o
@@ -33,7 +34,6 @@ obj-$(CONFIG_FSL_QSPI) += fsl_qspi.o
obj-$(CONFIG_ICH_SPI) += ich.o
obj-$(CONFIG_LPC32XX_SSP) += lpc32xx_ssp.o
obj-$(CONFIG_MPC8XX_SPI) += mpc8xx_spi.o
-obj-$(CONFIG_MPC8XXX_SPI) += mpc8xxx_spi.o
obj-$(CONFIG_MT7621_SPI) += mt7621_spi.o
obj-$(CONFIG_MVEBU_A3700_SPI) += mvebu_a3700_spi.o
obj-$(CONFIG_MXC_SPI) += mxc_spi.o
diff --git a/drivers/spi/mpc8xxx_spi.c b/drivers/spi/mpc8xxx_spi.c
index 63e1a150f8..1c7bf10f91 100644
--- a/drivers/spi/mpc8xxx_spi.c
+++ b/drivers/spi/mpc8xxx_spi.c
@@ -5,10 +5,12 @@
*/
#include <common.h>
-
+#include <dm.h>
+#include <errno.h>
#include <malloc.h>
#include <spi.h>
#include <asm/mpc8xxx_spi.h>
+#include <asm-generic/gpio.h>
enum {
SPI_EV_NE = BIT(31 - 22), /* Receiver Not Empty */
@@ -30,6 +32,12 @@ enum {
SPI_COM_LST = BIT(31 - 9),
};
+struct mpc8xxx_priv {
+ spi8xxx_t *spi;
+ struct gpio_desc gpios[16];
+ int max_cs;
+};
+
static inline u32 to_prescale_mod(u32 val)
{
return (min(val, (u32)15) << 16);
@@ -42,70 +50,90 @@ static void set_char_len(spi8xxx_t *spi, u32 val)
#define SPI_TIMEOUT 1000
-struct spi_slave *spi_setup_slave(uint bus, uint cs, uint max_hz, uint mode)
+static int __spi_set_speed(spi8xxx_t *spi, uint speed)
{
- struct spi_slave *slave;
+ /* TODO(mario.six at gdsys.cc): This only ever sets one fixed speed */
- if (!spi_cs_is_valid(bus, cs))
- return NULL;
-
- slave = spi_alloc_slave_base(bus, cs);
- if (!slave)
- return NULL;
-
- /*
- * TODO: Some of the code in spi_init() should probably move
- * here, or into spi_claim_bus() below.
- */
+ /* Use SYSCLK / 8 (16.67MHz typ.) */
+ clrsetbits_be32(&spi->mode, SPI_MODE_PM_MASK, to_prescale_mod(1));
- return slave;
+ return 0;
}
-void spi_free_slave(struct spi_slave *slave)
+static int mpc8xxx_spi_ofdata_to_platdata(struct udevice *dev)
{
- free(slave);
+ struct mpc8xxx_priv *priv = dev_get_priv(dev);
+ int ret;
+
+ priv->spi = (spi8xxx_t *)dev_read_addr(dev);
+
+ /* TODO(mario.six at gdsys.cc): Read clock and save the value */
+
+ ret = gpio_request_list_by_name(dev, "gpios", priv->gpios,
+ ARRAY_SIZE(priv->gpios), GPIOD_IS_OUT | GPIOD_ACTIVE_LOW);
+ if (ret < 0)
+ return -EINVAL;
+
+ priv->max_cs = ret;
+
+ return 0;
}
-void spi_init(void)
+static int mpc8xxx_spi_probe(struct udevice *dev)
{
- spi8xxx_t *spi = &((immap_t *)(CONFIG_SYS_IMMR))->spi;
+ struct mpc8xxx_priv *priv = dev_get_priv(dev);
/*
* SPI pins on the MPC83xx are not muxed, so all we do is initialize
* some registers
*/
- out_be32(&spi->mode, SPI_MODE_REV | SPI_MODE_MS | SPI_MODE_EN);
- /* Use SYSCLK / 8 (16.67MHz typ.) */
- clrsetbits_be32(&spi->mode, SPI_MODE_PM_MASK, to_prescale_mod(1));
+ out_be32(&priv->spi->mode, SPI_MODE_REV | SPI_MODE_MS | SPI_MODE_EN);
+
+ __spi_set_speed(priv->spi, 16666667);
+
/* Clear all SPI events */
- setbits_be32(&spi->event, 0xffffffff);
+ setbits_be32(&priv->spi->event, 0xffffffff);
/* Mask all SPI interrupts */
- clrbits_be32(&spi->mask, 0xffffffff);
+ clrbits_be32(&priv->spi->mask, 0xffffffff);
/* LST bit doesn't do anything, so disregard */
- out_be32(&spi->com, 0);
+ out_be32(&priv->spi->com, 0);
+
+ return 0;
}
-int spi_claim_bus(struct spi_slave *slave)
+static void mpc8xxx_spi_cs_activate(struct udevice *dev)
{
- return 0;
+ struct mpc8xxx_priv *priv = dev_get_priv(dev->parent);
+ struct dm_spi_slave_platdata *platdata = dev_get_parent_platdata(dev);
+
+ dm_gpio_set_dir_flags(&priv->gpios[platdata->cs], GPIOD_IS_OUT);
+ dm_gpio_set_value(&priv->gpios[platdata->cs], 0);
}
-void spi_release_bus(struct spi_slave *slave)
+static void mpc8xxx_spi_cs_deactivate(struct udevice *dev)
{
+ struct mpc8xxx_priv *priv = dev_get_priv(dev->parent);
+ struct dm_spi_slave_platdata *platdata = dev_get_parent_platdata(dev);
+
+ dm_gpio_set_dir_flags(&priv->gpios[platdata->cs], GPIOD_IS_OUT);
+ dm_gpio_set_value(&priv->gpios[platdata->cs], 1);
}
-int spi_xfer(struct spi_slave *slave, uint bitlen, const void *dout, void *din,
- ulong flags)
+static int mpc8xxx_spi_xfer(struct udevice *dev, uint bitlen,
+ const void *dout, void *din, ulong flags)
{
- spi8xxx_t *spi = &((immap_t *)(CONFIG_SYS_IMMR))->spi;
- u32 tmpdin;
+ struct udevice *bus = dev->parent;
+ struct mpc8xxx_priv *priv = dev_get_priv(bus);
+ spi8xxx_t *spi = priv->spi;
+ struct dm_spi_slave_platdata *platdata = dev_get_parent_platdata(dev);
+ u32 tmpdin = 0;
int num_blks = DIV_ROUND_UP(bitlen, 32);
- debug("%s: slave %u:%u dout %08X din %08X bitlen %u\n", __func__,
- slave->bus, slave->cs, *(uint *)dout, *(uint *)din, bitlen);
+ debug("%s: slave %s:%u dout %08X din %08X bitlen %u\n", __func__,
+ bus->name, platdata->cs, *(uint *)dout, *(uint *)din, bitlen);
if (flags & SPI_XFER_BEGIN)
- spi_cs_activate(slave);
+ mpc8xxx_spi_cs_activate(dev);
/* Clear all SPI events */
setbits_be32(&spi->event, 0xffffffff);
@@ -178,15 +206,57 @@ int spi_xfer(struct spi_slave *slave, uint bitlen, const void *dout, void *din,
mdelay(1);
} while (get_timer(start) < SPI_TIMEOUT);
- if (get_timer(start) >= SPI_TIMEOUT)
+ if (get_timer(start) >= SPI_TIMEOUT) {
debug("*** %s: Time out during SPI transfer\n",
__func__);
+ return -ETIMEDOUT;
+ }
debug("*** %s: transfer ended. Value=%08x\n", __func__, tmpdin);
}
if (flags & SPI_XFER_END)
- spi_cs_deactivate(slave);
+ mpc8xxx_spi_cs_deactivate(dev);
+
+ return 0;
+}
+
+static int mpc8xxx_spi_set_speed(struct udevice *dev, uint speed)
+{
+ struct mpc8xxx_priv *priv = dev_get_priv(dev);
+
+ return __spi_set_speed(priv->spi, speed);
+}
+static int mpc8xxx_spi_set_mode(struct udevice *dev, uint mode)
+{
+ /* TODO(mario.six at gdsys.cc): Using SPI_CPHA (for clock phase) and
+ * SPI_CPOL (for clock polarity) should work
+ */
return 0;
}
+
+static const struct dm_spi_ops mpc8xxx_spi_ops = {
+ .xfer = mpc8xxx_spi_xfer,
+ .set_speed = mpc8xxx_spi_set_speed,
+ .set_mode = mpc8xxx_spi_set_mode,
+ /*
+ * cs_info is not needed, since we require all chip selects to be
+ * in the device tree explicitly
+ */
+};
+
+static const struct udevice_id mpc8xxx_spi_ids[] = {
+ { .compatible = "fsl,spi" },
+ { }
+};
+
+U_BOOT_DRIVER(mpc8xxx_spi) = {
+ .name = "mpc8xxx_spi",
+ .id = UCLASS_SPI,
+ .of_match = mpc8xxx_spi_ids,
+ .ops = &mpc8xxx_spi_ops,
+ .ofdata_to_platdata = mpc8xxx_spi_ofdata_to_platdata,
+ .probe = mpc8xxx_spi_probe,
+ .priv_auto_alloc_size = sizeof(struct mpc8xxx_priv),
+};
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 500853fc95..8116193d27 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -42,6 +42,7 @@ void *spi_do_alloc_slave(int offset, int size, unsigned int bus,
#if !defined(CONFIG_DM_SPI) && \
defined(CONFIG_DAVINCI_SPI) || \
defined(CONFIG_KIRKWOOD_SPI) || \
+ defined(CONFIG_MPC8XXX_SPI) || \
defined(CONFIG_TI_QSPI)
void spi_cs_activate(struct spi_slave *slave)
{
--
2.18.0.321.gffc6fa0e3
More information about the U-Boot
mailing list