[U-Boot] [PATCH v2 01/32] spi: davinci: Full dm conversion
Jagan Teki
jagan at amarulasolutions.com
Sun Nov 25 17:28:22 UTC 2018
davinci_spi now support dt along with platform data,
respective boards need to switch into dm for the same.
Cc: Adam Ford <aford173 at gmail.com>
Cc: Vitaly Andrianov <vitalya at ti.com>
Cc: Stefano Babic <sbabic at denx.de>
Cc: Peter Howard <phoward at gme.net.au>
Cc: Tom Rini <trini at konsulko.com>
Signed-off-by: Jagan Teki <jagan at amarulasolutions.com>
---
Makefile | 9 +++
drivers/spi/Makefile | 2 +-
drivers/spi/davinci_spi.c | 157 --------------------------------------
drivers/spi/spi.c | 38 +++++++++
4 files changed, 48 insertions(+), 158 deletions(-)
diff --git a/Makefile b/Makefile
index 552687db53..d06cb5c287 100644
--- a/Makefile
+++ b/Makefile
@@ -917,6 +917,15 @@ ifeq ($(CONFIG_DM_I2C_COMPAT)$(CONFIG_SANDBOX),y)
@echo "(possibly in a subsequent patch in your series)"
@echo "before sending patches to the mailing list."
@echo "===================================================="
+endif
+ifeq ($(CONFIG_DM_SPI),)
+ifeq ($(CONFIG_DAVINCI_SPI),y)
+ @echo "===================== WARNING ======================"
+ @echo "This board uses SPI driver from drivers/spi/ without"
+ @echo "enabling CONFIG_DM_SPI. Please enable CONFIG_DM_SPI"
+ @echo "otherwise SPI on this board, cannot work."
+ @echo "===================================================="
+endif
endif
@# Check that this build does not use CONFIG options that we do not
@# know about unless they are in Kconfig. All the existing CONFIG
diff --git a/drivers/spi/Makefile b/drivers/spi/Makefile
index 7242ea7e40..cf5a5cccc0 100644
--- a/drivers/spi/Makefile
+++ b/drivers/spi/Makefile
@@ -6,6 +6,7 @@
# There are many options which enable SPI, so make this library available
ifdef CONFIG_DM_SPI
obj-y += spi-uclass.o
+obj-$(CONFIG_DAVINCI_SPI) += davinci_spi.o
obj-$(CONFIG_SANDBOX) += spi-emul-uclass.o
obj-$(CONFIG_SOFT_SPI) += soft_spi.o
obj-$(CONFIG_SPI_MEM) += spi-mem.o
@@ -22,7 +23,6 @@ obj-$(CONFIG_BCM63XX_SPI) += bcm63xx_spi.o
obj-$(CONFIG_BCMSTB_SPI) += bcmstb_spi.o
obj-$(CONFIG_CADENCE_QSPI) += cadence_qspi.o cadence_qspi_apb.o
obj-$(CONFIG_CF_SPI) += cf_spi.o
-obj-$(CONFIG_DAVINCI_SPI) += davinci_spi.o
obj-$(CONFIG_DESIGNWARE_SPI) += designware_spi.o
obj-$(CONFIG_EXYNOS_SPI) += exynos_spi.o
obj-$(CONFIG_FSL_DSPI) += fsl_dspi.o
diff --git a/drivers/spi/davinci_spi.c b/drivers/spi/davinci_spi.c
index 4d2c106440..c1646f6cdc 100644
--- a/drivers/spi/davinci_spi.c
+++ b/drivers/spi/davinci_spi.c
@@ -52,41 +52,6 @@
/* SPIDEF */
#define SPIDEF_CSDEF0_MASK BIT(0)
-#ifndef CONFIG_DM_SPI
-#define SPI0_BUS 0
-#define SPI0_BASE CONFIG_SYS_SPI_BASE
-/*
- * Define default SPI0_NUM_CS as 1 for existing platforms that uses this
- * driver. Platform can configure number of CS using CONFIG_SYS_SPI0_NUM_CS
- * if more than one CS is supported and by defining CONFIG_SYS_SPI0.
- */
-#ifndef CONFIG_SYS_SPI0
-#define SPI0_NUM_CS 1
-#else
-#define SPI0_NUM_CS CONFIG_SYS_SPI0_NUM_CS
-#endif
-
-/*
- * define CONFIG_SYS_SPI1 when platform has spi-1 device (bus #1) and
- * CONFIG_SYS_SPI1_NUM_CS defines number of CS on this bus
- */
-#ifdef CONFIG_SYS_SPI1
-#define SPI1_BUS 1
-#define SPI1_NUM_CS CONFIG_SYS_SPI1_NUM_CS
-#define SPI1_BASE CONFIG_SYS_SPI1_BASE
-#endif
-
-/*
- * define CONFIG_SYS_SPI2 when platform has spi-2 device (bus #2) and
- * CONFIG_SYS_SPI2_NUM_CS defines number of CS on this bus
- */
-#ifdef CONFIG_SYS_SPI2
-#define SPI2_BUS 2
-#define SPI2_NUM_CS CONFIG_SYS_SPI2_NUM_CS
-#define SPI2_BASE CONFIG_SYS_SPI2_BASE
-#endif
-#endif
-
DECLARE_GLOBAL_DATA_PTR;
/* davinci spi register set */
@@ -119,9 +84,6 @@ struct davinci_spi_regs {
/* davinci spi slave */
struct davinci_spi_slave {
-#ifndef CONFIG_DM_SPI
- struct spi_slave slave;
-#endif
struct davinci_spi_regs *regs;
unsigned int freq; /* current SPI bus frequency */
unsigned int mode; /* current SPI mode used */
@@ -343,124 +305,6 @@ out:
return 0;
}
-#ifndef CONFIG_DM_SPI
-
-static inline struct davinci_spi_slave *to_davinci_spi(struct spi_slave *slave)
-{
- return container_of(slave, struct davinci_spi_slave, slave);
-}
-
-int spi_cs_is_valid(unsigned int bus, unsigned int cs)
-{
- int ret = 0;
-
- switch (bus) {
- case SPI0_BUS:
- if (cs < SPI0_NUM_CS)
- ret = 1;
- break;
-#ifdef CONFIG_SYS_SPI1
- case SPI1_BUS:
- if (cs < SPI1_NUM_CS)
- ret = 1;
- break;
-#endif
-#ifdef CONFIG_SYS_SPI2
- case SPI2_BUS:
- if (cs < SPI2_NUM_CS)
- ret = 1;
- break;
-#endif
- default:
- /* Invalid bus number. Do nothing */
- break;
- }
- return ret;
-}
-
-void spi_cs_activate(struct spi_slave *slave)
-{
- /* do nothing */
-}
-
-void spi_cs_deactivate(struct spi_slave *slave)
-{
- /* do nothing */
-}
-
-struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
- unsigned int max_hz, unsigned int mode)
-{
- struct davinci_spi_slave *ds;
-
- if (!spi_cs_is_valid(bus, cs))
- return NULL;
-
- ds = spi_alloc_slave(struct davinci_spi_slave, bus, cs);
- if (!ds)
- return NULL;
-
- switch (bus) {
- case SPI0_BUS:
- ds->regs = (struct davinci_spi_regs *)SPI0_BASE;
- break;
-#ifdef CONFIG_SYS_SPI1
- case SPI1_BUS:
- ds->regs = (struct davinci_spi_regs *)SPI1_BASE;
- break;
-#endif
-#ifdef CONFIG_SYS_SPI2
- case SPI2_BUS:
- ds->regs = (struct davinci_spi_regs *)SPI2_BASE;
- break;
-#endif
- default: /* Invalid bus number */
- return NULL;
- }
-
- ds->freq = max_hz;
- ds->mode = mode;
-
- return &ds->slave;
-}
-
-void spi_free_slave(struct spi_slave *slave)
-{
- struct davinci_spi_slave *ds = to_davinci_spi(slave);
-
- free(ds);
-}
-
-int spi_xfer(struct spi_slave *slave, unsigned int bitlen,
- const void *dout, void *din, unsigned long flags)
-{
- struct davinci_spi_slave *ds = to_davinci_spi(slave);
-
- ds->cur_cs = slave->cs;
-
- return __davinci_spi_xfer(ds, bitlen, dout, din, flags);
-}
-
-int spi_claim_bus(struct spi_slave *slave)
-{
- struct davinci_spi_slave *ds = to_davinci_spi(slave);
-
-#ifdef CONFIG_SPI_HALF_DUPLEX
- ds->half_duplex = true;
-#else
- ds->half_duplex = false;
-#endif
- return __davinci_spi_claim_bus(ds, ds->slave.cs);
-}
-
-void spi_release_bus(struct spi_slave *slave)
-{
- struct davinci_spi_slave *ds = to_davinci_spi(slave);
-
- __davinci_spi_release_bus(ds);
-}
-
-#else
static int davinci_spi_set_speed(struct udevice *bus, uint max_hz)
{
struct davinci_spi_slave *ds = dev_get_priv(bus);
@@ -579,4 +423,3 @@ U_BOOT_DRIVER(davinci_spi) = {
.ops = &davinci_spi_ops,
.priv_auto_alloc_size = sizeof(struct davinci_spi_slave),
};
-#endif
diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
index 22910de0dd..4d1ade797b 100644
--- a/drivers/spi/spi.c
+++ b/drivers/spi/spi.c
@@ -38,3 +38,41 @@ void *spi_do_alloc_slave(int offset, int size, unsigned int bus,
return ptr;
}
+
+/**
+ * These are non-dm spi core operations, will remove once all driver
+ * converted into full driver model.
+ */
+__weak void spi_cs_activate(struct spi_slave *slave)
+{
+}
+
+__weak void spi_cs_deactivate(struct spi_slave *slave)
+{
+}
+
+__weak struct spi_slave *spi_setup_slave(unsigned int bus, unsigned int cs,
+ unsigned int max_hz,
+ unsigned int mode)
+{
+ return NULL;
+}
+
+__weak void spi_free_slave(struct spi_slave *slave)
+{
+}
+
+__weak int spi_xfer(struct spi_slave *slave, unsigned int bitlen,
+ const void *dout, void *din, unsigned long flags)
+{
+ return 0;
+}
+
+__weak int spi_claim_bus(struct spi_slave *slave)
+{
+ return 0;
+}
+
+__weak void spi_release_bus(struct spi_slave *slave)
+{
+}
--
2.18.0.321.gffc6fa0e3
More information about the U-Boot
mailing list