[U-Boot] [PATCH v3 6/8] powerpc: mpc85xx: Use binman to embed dtb inside U-Boot

[Simon Glass]

On 3 September 2018 at 18:05, Jagdish Gediya <jagdish.gediya at nxp.com> wrote:
> Below is the sequence to embed dtb inside U-Boot,
> 1. Remove bootpg and resetvec section if needed
> 2. Append dtb
> 3. Append bootpg and resetvec section back if removed in step 1
>
> Above procedure is required only when CONFIG_MPC85xx and
> CONFIG_OF_SEPARATE are defined.
>
> Add new config CONFIG_MPC85XX_HAVE_RESET_VECTOR to indicate that
> image has resetvec section. Step 1 and step 3 described above are
> required only if this config is y.
>
> Signed-off-by: Jagdish Gediya <jagdish.gediya at nxp.com>
> ---
> Changes for v2:
>         - Don't change the generic target
>         - Add new config option to use binman

Where is that config option? I don't see it in this patch.

>
> Changes for v3:
>         - Commit message change('u-boot' -> 'U-Boot')
>
>  Makefile                         | 23 ++++++++++++++++++++++-
>  arch/powerpc/cpu/mpc85xx/Kconfig |  4 ++++
>  2 files changed, 26 insertions(+), 1 deletion(-)

Reviewed-by: Simon Glass <sjg at chromium.org>