[U-Boot] [Patch V2] ARM: da850evm_direct_nor_defconfig: Enable DM_SERIAL

Adam Ford aford173 at gmail.com
Wed Sep 19 03:58:17 UTC 2018


With DM enabled, this patch enables DM_SERIAL and removes
the NS16550 initialization from da850_lowlevel since the driver
will take care of that itself.

Signed-off-by: Adam Ford <aford173 at gmail.com>
---
V2:  Rebase against Master
     Use CONFIG_IS_ENABLED instead of defined so this can be 
     enabled/disabled in SPL independently.
     Enable CONFIG_SYS_MALLOC_F to allow relocation allowing the serial to build correctly
diff --git a/arch/arm/mach-davinci/da850_lowlevel.c b/arch/arm/mach-davinci/da850_lowlevel.c
index 95dc93a24f..822e0dc4a1 100644
--- a/arch/arm/mach-davinci/da850_lowlevel.c
+++ b/arch/arm/mach-davinci/da850_lowlevel.c
@@ -288,10 +288,10 @@ int arch_cpu_init(void)
 	/* GPIO setup */
 	board_gpio_init();
 
-
+#if !CONFIG_IS_ENABLED(DM_SERIAL)
 	NS16550_init((NS16550_t)(CONFIG_SYS_NS16550_COM1),
 			CONFIG_SYS_NS16550_CLK / 16 / CONFIG_BAUDRATE);
-
+#endif
 	/*
 	 * Fix Power and Emulation Management Register
 	 * see sprufw3a.pdf page 37 Table 24
diff --git a/configs/da850evm_direct_nor_defconfig b/configs/da850evm_direct_nor_defconfig
index 4039d0ee59..42cb4127fd 100644
--- a/configs/da850evm_direct_nor_defconfig
+++ b/configs/da850evm_direct_nor_defconfig
@@ -5,7 +5,6 @@ CONFIG_TARGET_DA850EVM=y
 CONFIG_DA850_LOWLEVEL=y
 CONFIG_TI_COMMON_CMD_OPTIONS=y
 CONFIG_NR_DRAM_BANKS=1
-# CONFIG_SYS_MALLOC_F is not set
 CONFIG_SYS_EXTRA_OPTIONS="USE_NOR,DIRECT_NOR_BOOT"
 CONFIG_BOOTDELAY=3
 CONFIG_USE_BOOTARGS=y
@@ -50,6 +49,8 @@ CONFIG_SPI_FLASH_STMICRO=y
 CONFIG_SPI_FLASH_WINBOND=y
 CONFIG_MII=y
 CONFIG_DRIVER_TI_EMAC=y
+CONFIG_SPECIFY_CONSOLE_INDEX=y
+CONFIG_DM_SERIAL=y
 CONFIG_SYS_NS16550=y
 CONFIG_SPI=y
 CONFIG_DM_SPI=y
-- 
2.17.1



More information about the U-Boot mailing list