[U-Boot] [Patch V3] ARM: da850evm_direct_nor_defconfig: Enable DM_SERIAL
Adam Ford
aford173 at gmail.com
Wed Sep 19 21:06:49 UTC 2018
With DM enabled, this patch enables DM_SERIAL and removes
the NS16550 initialization from da850_lowlevel since the driver
will take care of that itself.
Signed-off-by: Adam Ford <aford173 at gmail.com>
---
V3: Make the include items referencing the serial info
dependent on DM_SERIAL and not SPL or NOR since
both of these options will eventually use DM_SERIAL.
V2: Rebase against Master
Use CONFIG_IS_ENABLED instead of defined so this can be
enabled/disabled in SPL independently.
Enable CONFIG_SYS_MALLOC_F to allow relocation allowing the serial to build correctly
diff --git a/arch/arm/mach-davinci/da850_lowlevel.c b/arch/arm/mach-davinci/da850_lowlevel.c
index 95dc93a24f..822e0dc4a1 100644
--- a/arch/arm/mach-davinci/da850_lowlevel.c
+++ b/arch/arm/mach-davinci/da850_lowlevel.c
@@ -288,10 +288,10 @@ int arch_cpu_init(void)
/* GPIO setup */
board_gpio_init();
-
+#if !CONFIG_IS_ENABLED(DM_SERIAL)
NS16550_init((NS16550_t)(CONFIG_SYS_NS16550_COM1),
CONFIG_SYS_NS16550_CLK / 16 / CONFIG_BAUDRATE);
-
+#endif
/*
* Fix Power and Emulation Management Register
* see sprufw3a.pdf page 37 Table 24
diff --git a/configs/da850evm_direct_nor_defconfig b/configs/da850evm_direct_nor_defconfig
index 4039d0ee59..42cb4127fd 100644
--- a/configs/da850evm_direct_nor_defconfig
+++ b/configs/da850evm_direct_nor_defconfig
@@ -5,7 +5,6 @@ CONFIG_TARGET_DA850EVM=y
CONFIG_DA850_LOWLEVEL=y
CONFIG_TI_COMMON_CMD_OPTIONS=y
CONFIG_NR_DRAM_BANKS=1
-# CONFIG_SYS_MALLOC_F is not set
CONFIG_SYS_EXTRA_OPTIONS="USE_NOR,DIRECT_NOR_BOOT"
CONFIG_BOOTDELAY=3
CONFIG_USE_BOOTARGS=y
@@ -50,6 +49,8 @@ CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_WINBOND=y
CONFIG_MII=y
CONFIG_DRIVER_TI_EMAC=y
+CONFIG_SPECIFY_CONSOLE_INDEX=y
+CONFIG_DM_SERIAL=y
CONFIG_SYS_NS16550=y
CONFIG_SPI=y
CONFIG_DM_SPI=y
diff --git a/include/configs/da850evm.h b/include/configs/da850evm.h
index 14a6b9e591..319f6aadf5 100644
--- a/include/configs/da850evm.h
+++ b/include/configs/da850evm.h
@@ -116,7 +116,7 @@
* Serial Driver info
*/
-#if defined(CONFIG_SPL_BUILD) || defined(CONFIG_DIRECT_NOR_BOOT)
+#if !CONFIG_IS_ENABLED(DM_SERIAL)
#define CONFIG_SYS_NS16550_SERIAL
#define CONFIG_SYS_NS16550_REG_SIZE -4 /* NS16550 register size */
#define CONFIG_SYS_NS16550_COM1 DAVINCI_UART2_BASE /* Base address of UART2 */
--
2.17.1
More information about the U-Boot
mailing list