[U-Boot] [RFT PATCH v2 2/2] sunxi: Enable EMAC on the Bananapi M3

[Chen-Yu Tsai]

From: Chen-Yu Tsai <wens at csie.org>

The Bananapi M3 has an RTL8211E PHY connected to the EMAC using
RGMII. The PHY is powered by DCDC1 through SW @ 3.3V.

The board is designed to use 3.3V with RGMII, instead of the standard
reduced voltage of 2.5V we see everywhere. DLDO3, which provides the
I/O voltages, is raised to match.

This patch enables the EMAC and Realtek PHY drivers in the defconfig.
The device tree file already has the EMAC enabled.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>

---

Changes in v2:
  - Dropped clk/reset related changes in favor of DM CLK / RESET support
  - Raised DLDO3 for RGMII I/O on Bananapi M3 to 3.3V per design

 configs/Sinovoip_BPI_M3_defconfig | 4 +++-
 1 file changed, 3 insertions(+), 1 deletion(-)

diff --git a/configs/Sinovoip_BPI_M3_defconfig b/configs/Sinovoip_BPI_M3_defconfig
index 79743a9c9a51..b9ab00cb8a29 100644
--- a/configs/Sinovoip_BPI_M3_defconfig
+++ b/configs/Sinovoip_BPI_M3_defconfig
@@ -21,8 +21,10 @@ CONFIG_CONSOLE_MUX=y
 # CONFIG_SPL_DOS_PARTITION is not set
 # CONFIG_SPL_EFI_PARTITION is not set
 CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-bananapi-m3"
+CONFIG_PHY_REALTEK=y
+CONFIG_SUN8I_EMAC=y
 CONFIG_AXP_DCDC5_VOLT=1200
-CONFIG_AXP_DLDO3_VOLT=2500
+CONFIG_AXP_DLDO3_VOLT=3300
 CONFIG_AXP_SW_ON=y
 CONFIG_USB_EHCI_HCD=y
 CONFIG_USB_OHCI_HCD=y
-- 
2.20.1