[U-Boot] [PATCH v2 5/5] board: toradex: add colibri imx8qxp 2gb wb it v1.0b module support

[Stefano Babic]

Hi Marcel,

On 25/04/19 14:35, Marcel Ziswiler wrote:
> Hi Stefano
> 
> On Thu, 2019-04-25 at 12:48 +0200, Stefano Babic wrote:
>> Hi Marcel,
>>
>> On 09/04/19 17:25, Marcel Ziswiler wrote:
>>> From: Marcel Ziswiler <marcel.ziswiler at toradex.com>
>>>
>>> This commit adds initial support for the Toradex Colibri iMX8QXP
>>> 2GB WB
>>> IT V1.0B module. Unlike the V1.0A early access samples exclusively
>>> booting from SD card, they are now strapped to boot from eFuses
>>> which
>>> are factory fused to properly boot from their on-module eMMC. U-
>>> Boot
>>> supports either booting from the on-module eMMC or may be used for
>>> recovery purpose using the universal update utility (uuu) aka
>>> mfgtools
>>> 3.0.
>>>
>>> Functionality wise the following is known to be working:
>>> - eMMC and MMC/SD card
>>> - Ethernet
>>> - GPIOs
>>> - I2C
>>>
>>> Unfortunately, there is no USB functionality for the i.MX 8QXP as
>>> of
>>> yet.
>>>
>>> Signed-off-by: Marcel Ziswiler <marcel.ziswiler at toradex.com>
>>>
>>> ---
>>>
>>
>> I merged the series and build locally (fine), but Travis complains
>> and
>> stops with error:
>>
>> +cc1: fatal error: opening output file spl/u-boot-spl.cfgout: No such
>> file or directory
>> +compilation terminated.
>>
>> Can you take a look at it ?
> 
> Sure, looks like Peng's commit caceb739ea07 ("imx: build flash.bin for
> i.MX8") takes SPL for granted while my patchset currently avoids it.

It looks so, yes.

> 
> BTW: I still don't believe SPL makes much sense on i.MX 8X given all
> the other proprietary parts involved in booting.

SPL makes more sense if it is possible to detect at runtime the HW and
change the configuration - for i.MX6, this means RAMS detection, which
boot device is booting, and so on.

On i.MX8 there is a lot of proprietary parts - we lose the flexibility
of SPL, and most features are lost (or must be provided by proprietary
code). I agree that on this platform SPL makes less sense, and i.MX8
should be built independently if CONFIG_SPL is set (this is also for
i.MX6 / MX5, there are boards without SPL and using the DCD image to set
up the RAM controller).

> Plus currently SPL
> actually breaks the USB serial downloader aka recovery mode using the
> universal update utility (uuu) aka mfgtools 3.0.
> 

Regards,
Stefano

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================