[U-Boot] [U-Boot,RESEND,10/10] imx: support i.MX8QM MEK board

[sbabic at denx.de]

> Add i.MX8QM MEK board support.
> Included a basic dts, enabled SPL FIT
> Boot log as below:
> U-Boot SPL 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800)
> Normal Boot
> Trying to boot from MMC2_2
> U-Boot 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800)
> CPU:   NXP i.MX8QM RevB A53 at 142933 MHz
> Model: Freescale i.MX8QM MEK
> Board: iMX8QM MEK
> Build: SCFW 9330215b
> Boot:  SD1
> DRAM:  6 GiB
> MMC:   FSL_SDHC: 0, FSL_SDHC: 1
> Loading Environment from MMC... *** Warning - bad CRC, using default environment
> In:    serial at 5a060000
> Out:   serial at 5a060000
> Err:   serial at 5a060000
> Net:
> Error: ethernet at 5b040000 address not set.
> eth-1: ethernet at 5b040000
> Hit any key to stop autoboot:  0
> Signed-off-by: Peng Fan <peng.fan at nxp.com>

Applied to u-boot-imx, master, thanks !

Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================