[U-Boot] [U-Boot,RESEND,10/10] imx: support i.MX8QM MEK board

[Stefano Babic]

On 26/04/19 12:50, Marcel Ziswiler wrote:
> Hi Stefano
> 
> On Fri, 2019-04-26 at 09:37 +0000, sbabic at denx.de wrote:
>>> Add i.MX8QM MEK board support.
>>> Included a basic dts, enabled SPL FIT
>>> Boot log as below:
>>> U-Boot SPL 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30
>>> +0800)
>>> Normal Boot
>>> Trying to boot from MMC2_2
>>> U-Boot 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800)
>>> CPU:   NXP i.MX8QM RevB A53 at 142933 MHz
>>> Model: Freescale i.MX8QM MEK
>>> Board: iMX8QM MEK
>>> Build: SCFW 9330215b
>>> Boot:  SD1
>>> DRAM:  6 GiB
>>> MMC:   FSL_SDHC: 0, FSL_SDHC: 1
>>> Loading Environment from MMC... *** Warning - bad CRC, using
>>> default environment
>>> In:    serial at 5a060000
>>> Out:   serial at 5a060000
>>> Err:   serial at 5a060000
>>> Net:
>>> Error: ethernet at 5b040000 address not set.
>>> eth-1: ethernet at 5b040000
>>> Hit any key to stop autoboot:  0
>>> Signed-off-by: Peng Fan <peng.fan at nxp.com>
>>
>> Applied to u-boot-imx, master, thanks !
> 
> This one introduced a superfluous trailing line continuation in the
> Makefile:
> 
> https://git.denx.de/?p=u-boot/u-boot-imx.git;a=commitdiff;h=0d331c035a091c1c1af4180b40bd234e3b87e80a#patch1
> 
> I will fix this and also make sure stuff is alphabetically sorted again
> in my updated Colibri iMX8X introduction patch. OK?

That's fine, thanks !


Best regards,
Stefano Babic

-- 
=====================================================================
DENX Software Engineering GmbH,      Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================