[U-Boot] [PATCH PATCH v4 01/15] spl: fit: don't load the firmware twice

[Jean-Jacques Hiblot]

When u-boot.img is a FIT image generated automatically by mkimage, the
configuration node has the following structure:
conf-1 {
   description = "k3-am654-base-board";
   firmware = "firmware-1";
   loadables = "firmware-1";
   fdt = "fdt-1";
};

The firmware is referenced twice. Once by the 'firmware' property and
once by the 'loadables' property. Currently this result in the firmware
being loaded twice. This is not a big problem but has an impact on the
boot time.
Fixing it by not loading a loadable image if it is also the firmware image.

Signed-off-by: Jean-Jacques Hiblot <jjhiblot at ti.com>
---

Changes in v4: New

 common/spl/spl_fit.c | 10 ++++++++++
 1 file changed, 10 insertions(+)

diff --git a/common/spl/spl_fit.c b/common/spl/spl_fit.c
index 969f7775c1..0de18e3975 100644
--- a/common/spl/spl_fit.c
+++ b/common/spl/spl_fit.c
@@ -361,6 +361,7 @@ int spl_load_simple_fit(struct spl_image_info *spl_image,
 	int images, ret;
 	int base_offset, hsize, align_len = ARCH_DMA_MINALIGN - 1;
 	int index = 0;
+	int firmware_node;
 
 	/*
 	 * For FIT with external data, figure out where the external images
@@ -490,6 +491,7 @@ int spl_load_simple_fit(struct spl_image_info *spl_image,
 		spl_fit_append_fdt(spl_image, info, sector, fit,
 				   images, base_offset);
 
+	firmware_node = node;
 	/* Now check if there are more images for us to load */
 	for (; ; index++) {
 		uint8_t os_type = IH_OS_INVALID;
@@ -498,6 +500,14 @@ int spl_load_simple_fit(struct spl_image_info *spl_image,
 		if (node < 0)
 			break;
 
+		/*
+		 * if the firmware is also a loadable, skip it because
+		 * it already has been loaded. This is typically the case with
+		 * u-boot.img generated by mkimage.
+		 */
+		if (firmware_node == node)
+			continue;
+
 		ret = spl_load_fit_image(info, sector, fit, base_offset, node,
 					 &image_info);
 		if (ret < 0)
-- 
2.17.1