[U-Boot] [PATCH 3/3] mmc: fsl_esdhc: rename fsl_esdhc_init to fsl_esdhc_get_cfg
Yangbo Lu
yangbo.lu at nxp.com
Mon Aug 19 08:27:50 UTC 2019
For non-DM code, below functions had similar names.
- fsl_esdhc_initialize
- fsl_esdhc_mmc_init
- fsl_esdhc_init
However fsl_esdhc_init was mainly used to get cfg. So rename it
to fsl_esdhc_get_cfg. Fix up bus-width capability handling, and
drop controller initialization because it will be re-initialized
in later esdhc_init_common for DM or esdhc_init for non-DM when use
it.
Signed-off-by: Yangbo Lu <yangbo.lu at nxp.com>
---
drivers/mmc/fsl_esdhc.c | 68 ++++++++-----------------------------------------
1 file changed, 11 insertions(+), 57 deletions(-)
diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
index d176bb3..bdf5b14 100644
--- a/drivers/mmc/fsl_esdhc.c
+++ b/drivers/mmc/fsl_esdhc.c
@@ -25,14 +25,6 @@
DECLARE_GLOBAL_DATA_PTR;
-#define ESDHC_IRQ_EN_BITS (IRQSTATEN_CC | IRQSTATEN_TC | \
- IRQSTATEN_DINT | IRQSTATEN_BWR | \
- IRQSTATEN_BRR | IRQSTATEN_CINT | \
- IRQSTATEN_CTOE | IRQSTATEN_CCE | \
- IRQSTATEN_CEBE | IRQSTATEN_CIE | \
- IRQSTATEN_DTOE | IRQSTATEN_DCE | \
- IRQSTATEN_DEBE)
-
struct fsl_esdhc {
uint dsaddr; /* SDMA system address register */
uint blkattr; /* Block attributes register */
@@ -651,55 +643,23 @@ static int esdhc_getcd_common(struct fsl_esdhc_priv *priv)
return timeout > 0;
}
-static int esdhc_reset(struct fsl_esdhc *regs)
-{
- ulong start;
-
- /* reset the controller */
- esdhc_setbits32(®s->sysctl, SYSCTL_RSTA);
-
- /* hardware clears the bit when it is done */
- start = get_timer(0);
- while ((esdhc_read32(®s->sysctl) & SYSCTL_RSTA)) {
- if (get_timer(start) > 100) {
- printf("MMC/SD: Reset never completed.\n");
- return -ETIMEDOUT;
- }
- }
-
- return 0;
-}
-
static const struct mmc_ops esdhc_ops;
-static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
- struct fsl_esdhc_plat *plat)
+static int fsl_esdhc_get_cfg(struct fsl_esdhc_priv *priv,
+ struct fsl_esdhc_plat *plat)
{
+ struct fsl_esdhc *regs = priv->esdhc_regs;
+ u32 caps, voltage_caps = 0;
struct mmc_config *cfg;
- struct fsl_esdhc *regs;
- u32 caps, voltage_caps;
- int ret;
if (!priv)
return -EINVAL;
- regs = priv->esdhc_regs;
-
- /* First reset the eSDHC controller */
- ret = esdhc_reset(regs);
- if (ret)
- return ret;
-
- esdhc_setbits32(®s->sysctl, SYSCTL_PEREN | SYSCTL_HCKEN |
- SYSCTL_IPGEN | SYSCTL_CKEN);
-
- writel(ESDHC_IRQ_EN_BITS, ®s->irqstaten);
cfg = &plat->cfg;
#ifndef CONFIG_DM_MMC
memset(cfg, '\0', sizeof(*cfg));
#endif
- voltage_caps = 0;
caps = esdhc_read32(®s->hostcapblt);
#ifdef CONFIG_SYS_FSL_ERRATUM_ESDHC135
@@ -737,18 +697,10 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
else if (priv->bus_width == 4)
cfg->host_caps = MMC_MODE_4BIT;
- cfg->host_caps = MMC_MODE_4BIT | MMC_MODE_8BIT;
#ifdef CONFIG_SYS_FSL_ESDHC_HAS_DDR_MODE
cfg->host_caps |= MMC_MODE_DDR_52MHz;
#endif
- if (priv->bus_width > 0) {
- if (priv->bus_width < 8)
- cfg->host_caps &= ~MMC_MODE_8BIT;
- if (priv->bus_width < 4)
- cfg->host_caps &= ~MMC_MODE_4BIT;
- }
-
if (caps & HOSTCAPBLT2_HSS)
cfg->host_caps |= MMC_MODE_HS_52MHz | MMC_MODE_HS;
@@ -759,7 +711,6 @@ static int fsl_esdhc_init(struct fsl_esdhc_priv *priv,
cfg->f_min = 400000;
cfg->f_max = min(priv->sdhc_clk, (u32)200000000);
-
cfg->b_max = CONFIG_SYS_MMC_MAX_BLK_COUNT;
return 0;
@@ -882,7 +833,10 @@ static int fsl_esdhc_cfg_to_priv(struct fsl_esdhc_cfg *cfg,
return -EINVAL;
priv->esdhc_regs = (struct fsl_esdhc *)(unsigned long)(cfg->esdhc_base);
- priv->bus_width = cfg->max_bus_width;
+ if (cfg->max_bus_width)
+ priv->bus_width = cfg->max_bus_width;
+ else
+ priv->bus_width = 4;
priv->sdhc_clk = cfg->sdhc_clk;
priv->wp_enable = cfg->wp_enable;
@@ -917,7 +871,7 @@ int fsl_esdhc_initialize(bd_t *bis, struct fsl_esdhc_cfg *cfg)
return ret;
}
- ret = fsl_esdhc_init(priv, plat);
+ ret = fsl_esdhc_get_cfg(priv, plat);
if (ret) {
debug("%s init failure\n", __func__);
free(plat);
@@ -1012,9 +966,9 @@ static int fsl_esdhc_probe(struct udevice *dev)
}
}
- ret = fsl_esdhc_init(priv, plat);
+ ret = fsl_esdhc_get_cfg(priv, plat);
if (ret) {
- dev_err(dev, "fsl_esdhc_init failure\n");
+ dev_err(dev, "fsl_esdhc_get_cfg failure\n");
return ret;
}
--
2.7.4
More information about the U-Boot
mailing list