[U-Boot] [PATCH v3 2/4] SDP: use CONFIG_SDP_LOADADDR as default load address

[Sherry Sun]

If SDP_WRITE and SDP_JUMP command addr is zero, use CONFIG_SDP_LOADADDR
as default address.

Signed-off-by: Sherry Sun <sherry.sun at nxp.com>
Signed-off-by: Frank Li <Frank.Li at nxp.com>
Reviewed-by: Lukasz Majewski <lukma at denx.de>
---
 drivers/usb/gadget/Kconfig | 4 ++++
 drivers/usb/gadget/f_sdp.c | 6 ++++--
 2 files changed, 8 insertions(+), 2 deletions(-)

diff --git a/drivers/usb/gadget/Kconfig b/drivers/usb/gadget/Kconfig
index 26b4d12a09..172a82195b 100644
--- a/drivers/usb/gadget/Kconfig
+++ b/drivers/usb/gadget/Kconfig
@@ -115,6 +115,10 @@ config USB_GADGET_VBUS_DRAW
 	   This value will be used except for system-specific gadget
 	   drivers that have more specific information.
 
+config SDP_LOADADDR
+	hex "Default load address at SDP_WRITE and SDP_JUMP"
+	default 0
+
 # Selected by UDC drivers that support high-speed operation.
 config USB_GADGET_DUALSPEED
 	bool
diff --git a/drivers/usb/gadget/f_sdp.c b/drivers/usb/gadget/f_sdp.c
index bcd1c5d47c..841814bc07 100644
--- a/drivers/usb/gadget/f_sdp.c
+++ b/drivers/usb/gadget/f_sdp.c
@@ -276,7 +276,8 @@ static void sdp_rx_command_complete(struct usb_ep *ep, struct usb_request *req)
 		sdp->error_status = SDP_WRITE_FILE_COMPLETE;
 
 		sdp->state = SDP_STATE_RX_FILE_DATA;
-		sdp->dnl_address = be32_to_cpu(cmd->addr);
+		sdp->dnl_address = cmd->addr ? be32_to_cpu(cmd->addr) :
+					       CONFIG_SDP_LOADADDR;
 		sdp->dnl_bytes_remaining = be32_to_cpu(cmd->cnt);
 		sdp->dnl_bytes = sdp->dnl_bytes_remaining;
 		sdp->next_state = SDP_STATE_IDLE;
@@ -304,7 +305,8 @@ static void sdp_rx_command_complete(struct usb_ep *ep, struct usb_request *req)
 		sdp->always_send_status = false;
 		sdp->error_status = 0;
 
-		sdp->jmp_address = be32_to_cpu(cmd->addr);
+		sdp->jmp_address = cmd->addr ? be32_to_cpu(cmd->addr) :
+					       CONFIG_SDP_LOADADDR;
 		sdp->state = SDP_STATE_TX_SEC_CONF;
 		sdp->next_state = SDP_STATE_JUMP;
 		break;
-- 
2.17.1