[U-Boot] [PATCH 5/5] mx6sabreauto: set SYS_MALLOC_F for video

Peng Fan peng.fan at nxp.com
Tue Jun 4 02:49:32 UTC 2019


> Subject: [PATCH 5/5] mx6sabreauto: set SYS_MALLOC_F for video
> 
> Sabre Auto boards currently hang with:
> ```
> U-Boot 2019.07-rc3-00057-gc41940c406 (Jun 03 2019 - 14:42:41 +0200)
> 
> CPU:   Freescale i.MX6QP rev1.0 996 MHz (running at 792 MHz)
> CPU:   Automotive temperature grade (-40C to 125C)Reset cause: WDOG
> Model: Freescale i.MX6 Quad Plus SABRE Automotive Board
> Board: MX6Q-Sabreauto revA
> I2C:   ready
> DRAM:  2 GiB
> Video device 'ipu at 2400000' cannot allocate frame buffer memory -ensure
> the device is set up before relocation Error binding driver 'ipuv3_video': -28
> Video device 'ipu at 2800000' cannot allocate frame buffer memory -ensure
> the device is set up before relocation Error binding driver 'ipuv3_video': -28
> Some drivers failed to bind Error binding driver 'generic_simple_bus': -28
> Some drivers failed to bind initcall sequence 8ffe00b8 failed at call 1780e93b
> (err=-28) ```
> 
> Set SYS_MALLOC_F_LEN to reserve_video to work.
> 
> This is similar to the change Peng Fan did for mx6sabresd (9002e735e717)
> 
> Signed-off-by: Sjoerd Simons <sjoerd.simons at collabora.co.uk>
> 
> ---
> 
>  configs/mx6sabreauto_defconfig | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/configs/mx6sabreauto_defconfig
> b/configs/mx6sabreauto_defconfig index 6903048d85..558b1cd996 100644
> --- a/configs/mx6sabreauto_defconfig
> +++ b/configs/mx6sabreauto_defconfig
> @@ -4,6 +4,7 @@ CONFIG_SYS_TEXT_BASE=0x17800000
> CONFIG_SPL_GPIO_SUPPORT=y  CONFIG_SPL_LIBCOMMON_SUPPORT=y
> CONFIG_SPL_LIBGENERIC_SUPPORT=y
> +CONFIG_SYS_MALLOC_F_LEN=0x4000
>  CONFIG_TARGET_MX6SABREAUTO=y
>  CONFIG_SPL_MMC_SUPPORT=y
>  CONFIG_SPL_SERIAL_SUPPORT=y
> @@ -11,7 +12,6 @@ CONFIG_NR_DRAM_BANKS=1  CONFIG_SPL=y
> CONFIG_SPL_LIBDISK_SUPPORT=y  CONFIG_NXP_BOARD_REVISION=y -#
> CONFIG_SYS_MALLOC_F is not set  CONFIG_FIT=y
> CONFIG_SPL_FIT_PRINT=y  CONFIG_SPL_LOAD_FIT=y
> --

Reviewed-by: Peng Fan <peng.fan at nxp.com>

> 2.20.1



More information about the U-Boot mailing list