[U-Boot] [PATCH v5 0/5] net: ethernet: ti: Introduce am654 gigabit eth switch subsystem driver
Keerthy
j-keerthy at ti.com
Thu Jun 6 12:13:14 UTC 2019
Add new driver for the TI AM65x SoC Gigabit Ethernet Switch subsystem (CPSW
NUSS). It has two ports and provides Ethernet packet communication for the
device and can be configured as an Ethernet switch. CPSW NUSS features: the
Reduced Gigabit Media Independent Interface (RGMII), Reduced Media
Independent Interface (RMII), and the Management Data Input/Output (MDIO)
interface for physical layer device (PHY) management. The TI AM65x SoC has
integrated two-port Gigabit Ethernet Switch subsystem into device MCU
domain named MCU_CPSW0. One Ethernet port (port 1) with selectable RGMII
and RMII interfaces and an internal Communications Port Programming
Interface (CPPI) port (Host port 0).
Host Port 0 CPPI Packet Streaming Interface interface supports 8 TX
channels and on RX channels operating by TI am654 NAVSS Unified DMA
Peripheral Root Complex (UDMA-P) controller.
Tested for tftp and booting to kernel on am654-evm.
Changes in v5:
* Rebased to latest which meant adapting to pinmux macro change.
Changes in v4:
* Patch1 caused dra7 config build warnings corrected them.
Grygorii Strashko (4):
net: ethernet: ti: Introduce am654 gigabit eth switch subsystem driver
arm64: dts: ti: k3-am65: add mcu cpsw node
arm64: dts: k3-am654-base-board: add mcu cpsw nuss pinmux and phy defs
configs: am65x_evm_a53: enable networking
Keerthy (1):
driver: net: ti: cpsw-mdio: use phys_addr_t for mdio_base addr
arch/arm/dts/k3-am65.dtsi | 2 +
arch/arm/dts/k3-am654-base-board-u-boot.dtsi | 170 ++++
configs/am65x_evm_a53_defconfig | 7 +
drivers/net/ti/Kconfig | 8 +
drivers/net/ti/Makefile | 1 +
drivers/net/ti/am65-cpsw-nuss.c | 794 +++++++++++++++++++
drivers/net/ti/cpsw_mdio.c | 4 +-
drivers/net/ti/cpsw_mdio.h | 2 +-
8 files changed, 985 insertions(+), 3 deletions(-)
create mode 100644 drivers/net/ti/am65-cpsw-nuss.c
--
2.17.1
More information about the U-Boot
mailing list