[U-Boot] [PATCH v4 8/8] pico-imx7d: enable boot without PMIC
sbabic at denx.de
sbabic at denx.de
Mon Jun 10 09:49:43 UTC 2019
> If PMIC is not probed successfully, it is still OK to boot
> with default configuration although power is not optimized.
> Default voltage of SW1A/SW1B is 1.1V/1.0V for PC32PF3000A1EP
> on pico according to table 42 of spec of PF3000 ver 9.0.
> Default mode of SW1A/SW1B is APS as expected(table 47).
> Signed-off-by: Jun Nie <jun.nie at linaro.org>
Applied to u-boot-imx, master, thanks !
Best regards,
Stefano Babic
--
=====================================================================
DENX Software Engineering GmbH, Managing Director: Wolfgang Denk
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sbabic at denx.de
=====================================================================
More information about the U-Boot
mailing list