[U-Boot] [PATCH] spl, Makefile: Take external offset into account for fit images
Sjoerd Simons
sjoerd.simons at collabora.co.uk
Tue Jun 18 20:13:20 UTC 2019
When building a FIT image for SPL to load also take into account the
configured external offset. This allows the SPL to load the u-boot FIT
image correctly when configuring SECURE_BOOT on i.mx6 is enabled
(with CONFIG_FIT_EXTERNAL_OFFSET=0x3000).
Note this doesn't allow secure booting; but it does allow an unsigned
SPL/u-boot with secure boot support eanbled to boot on open device.
Signed-off-by: Sjoerd Simons <sjoerd.simons at collabora.co.uk>
---
Makefile | 1 +
1 file changed, 1 insertion(+)
diff --git a/Makefile b/Makefile
index c55ffa265f..a8808aeefd 100644
--- a/Makefile
+++ b/Makefile
@@ -1240,6 +1240,7 @@ endif
ifdef CONFIG_SPL_LOAD_FIT
MKIMAGEFLAGS_u-boot.img = -f auto -A $(ARCH) -T firmware -C none -O u-boot \
-a $(CONFIG_SYS_TEXT_BASE) -e $(CONFIG_SYS_UBOOT_START) \
+ -p $(CONFIG_FIT_EXTERNAL_OFFSET) \
-n "U-Boot $(UBOOTRELEASE) for $(BOARD) board" -E \
$(patsubst %,-b arch/$(ARCH)/dts/%.dtb,$(subst ",,$(CONFIG_OF_LIST)))
else
--
2.20.1
More information about the U-Boot
mailing list