[U-Boot] [PATCH v3 4/4] efi_loader: disk: install file system protocol to a whole disk

[Heinrich Schuchardt]

On 10/4/19 5:05 AM, AKASHI Takahiro wrote:
> Currently, a whole disk without any partitions is not associated
> with EFI_SIMPLE_FILE_SYSTEM_PROTOCOL. So even if it houses some
> file system, there is a chance that we may not be able to access
> it, particularly, when accesses are to be attempted after searching
> that protocol against a device handle.
>
> With this patch, EFI_SIMPLE_FILE_SYSTEM_PROTOCOL is installed
> to such a disk if part_get_info() shows there is no partition
> table installed on it.
>
> Signed-off-by: AKASHI Takahiro <takahiro.akashi at linaro.org>
> ---
>  lib/efi_loader/efi_disk.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
>
> diff --git a/lib/efi_loader/efi_disk.c b/lib/efi_loader/efi_disk.c
> index 27329cadb6f1..4e1a1efed7ec 100644
> --- a/lib/efi_loader/efi_disk.c
> +++ b/lib/efi_loader/efi_disk.c
> @@ -329,7 +329,8 @@ static efi_status_t efi_disk_add_dev(
>  			       diskobj->dp);
>  	if (ret != EFI_SUCCESS)
>  		return ret;
> -	if (part >= 1 && efi_fs_exists(desc, part)) {
> +	/* partitions or whole disk without partitions */
> +	if (efi_fs_exists(desc, part)) {

As described in response to an earlier version of the patch series we
should only install the EFI protocols if no partition table exits.

Best regards

Heinrich Schuchardt

>  		diskobj->volume = efi_simple_file_system(desc, part,
>  							 diskobj->dp);
>  		ret = efi_add_protocol(&diskobj->header,
>