[U-Boot] [PATCH] spl: dm_mmc: Initialize only the required mmc device

Lokesh Vutla lokeshvutla at ti.com
Wed Oct 9 04:47:54 UTC 2019


Hi Peng,

On 10/09/19 7:50 AM, Peng Fan wrote:
>> Subject: [PATCH] spl: dm_mmc: Initialize only the required mmc device
>>
>> In SPL, all the available mmc devices gets initialized during boot.
>> This might not work in cases where clocks are not available for certain mmc
>> devices(other than boot device) and the support for enabling device might not
>> be ready.
>>
>> Texas Instruments' K3 J721E device having a central system controller
>> (dmsc) is one such example falling in this category. Below is the sequence for
>> the failing scenario:
>> - ROM comes up in SD mode and loads SPL by just initialing SD card.
>> - SPL loads dmsc firmware from SD Card.
>> Since ROM has enabled SD, SPL need not enable the SD, just need to re
>> initialize the card. But SPL is trying to initialize other MMC instances which
>> are in disabled state. Since dmsc firmware is not yet available, devices cannot
>> be enabled. So in SPL, initialize only the mmc device that is needed.
>>
>> Signed-off-by: Lokesh Vutla <lokeshvutla at ti.com>

Gentle Ping. Are you planning to take this patch for this merge window?

Thanks and regards,
Lokesh

>> ---
>>  common/spl/spl_mmc.c | 14 ++++----------
>>  drivers/mmc/mmc.c    | 24 ++++++++++++++++++++++++
>>  include/mmc.h        |  1 +
>>  3 files changed, 29 insertions(+), 10 deletions(-)
>>
>> diff --git a/common/spl/spl_mmc.c b/common/spl/spl_mmc.c index
>> b3619889f7..303f0f80bf 100644
>> --- a/common/spl/spl_mmc.c
>> +++ b/common/spl/spl_mmc.c
>> @@ -113,31 +113,25 @@ static int spl_mmc_get_device_index(u32
>> boot_device)
>>
>>  static int spl_mmc_find_device(struct mmc **mmcp, u32 boot_device)
>> { -#if CONFIG_IS_ENABLED(DM_MMC)
>> -	struct udevice *dev;
>> -#endif
>>  	int err, mmc_dev;
>>
>>  	mmc_dev = spl_mmc_get_device_index(boot_device);
>>  	if (mmc_dev < 0)
>>  		return mmc_dev;
>>
>> +#if CONFIG_IS_ENABLED(DM_MMC)
>> +	err = mmc_init_device(mmc_dev);
>> +#else
>>  	err = mmc_initialize(NULL);
>> +#endif /* DM_MMC */
>>  	if (err) {
>>  #ifdef CONFIG_SPL_LIBCOMMON_SUPPORT
>>  		printf("spl: could not initialize mmc. error: %d\n", err);  #endif
>>  		return err;
>>  	}
>> -
>> -#if CONFIG_IS_ENABLED(DM_MMC)
>> -	err = uclass_get_device(UCLASS_MMC, mmc_dev, &dev);
>> -	if (!err)
>> -		*mmcp = mmc_get_mmc_dev(dev);
>> -#else
>>  	*mmcp = find_mmc_device(mmc_dev);
>>  	err = *mmcp ? 0 : -ENODEV;
>> -#endif
>>  	if (err) {
>>  #ifdef CONFIG_SPL_LIBCOMMON_SUPPORT
>>  		printf("spl: could not find mmc device %d. error: %d\n", diff --git
>> a/drivers/mmc/mmc.c b/drivers/mmc/mmc.c index eecc7d687e..ec8f92ce8f
>> 100644
>> --- a/drivers/mmc/mmc.c
>> +++ b/drivers/mmc/mmc.c
>> @@ -2998,6 +2998,30 @@ int mmc_initialize(bd_t *bis)
>>  	return 0;
>>  }
>>
>> +#if CONFIG_IS_ENABLED(DM_MMC)
>> +int mmc_init_device(int num)
>> +{
>> +	struct udevice *dev;
>> +	struct mmc *m;
>> +	int ret;
>> +
>> +	ret = uclass_get_device(UCLASS_MMC, num, &dev);
>> +	if (ret)
>> +		return ret;
>> +
>> +	m = mmc_get_mmc_dev(dev);
>> +	if (!m)
>> +		return 0;
>> +#ifdef CONFIG_FSL_ESDHC_ADAPTER_IDENT
>> +	mmc_set_preinit(m, 1);
>> +#endif
>> +	if (m->preinit)
>> +		mmc_start_init(m);
>> +
>> +	return 0;
>> +}
>> +#endif
>> +
>>  #ifdef CONFIG_CMD_BKOPS_ENABLE
>>  int mmc_set_bkops_enable(struct mmc *mmc)  { diff --git
>> a/include/mmc.h b/include/mmc.h index 46422f41a4..878b4c9e57 100644
>> --- a/include/mmc.h
>> +++ b/include/mmc.h
>> @@ -698,6 +698,7 @@ void mmc_destroy(struct mmc *mmc);
>>   */
>>  int mmc_unbind(struct udevice *dev);
>>  int mmc_initialize(bd_t *bis);
>> +int mmc_init_device(int num);
>>  int mmc_init(struct mmc *mmc);
>>  int mmc_send_tuning(struct mmc *mmc, u32 opcode, int *cmd_error);
> 
> Reviewed-by: Peng Fan <peng.fan at nxp.com>
> 
>>
>> --
>> 2.22.0
> 


More information about the U-Boot mailing list