[U-Boot] [PATCH 1/2] arm: k3: Fix getting ti_sci handle

[Lokesh Vutla]

API get_ti_sci_handle() is relying on the device-tree node name
to be "dmsc" for probing the ti_sci device. But with the introduction
of debug messages for dmsc, the node name changed to dmsc at 44083000.
Because of this ti_sci is never probed cause a boot failure. Instead
of relying on device-tree node name, use the first available firmware
node for probing ti_sci.

Signed-off-by: Lokesh Vutla <lokeshvutla at ti.com>
---
 arch/arm/mach-k3/common.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/arch/arm/mach-k3/common.c b/arch/arm/mach-k3/common.c
index bab5ffdf40..3e36d90ace 100644
--- a/arch/arm/mach-k3/common.c
+++ b/arch/arm/mach-k3/common.c
@@ -20,7 +20,7 @@ struct ti_sci_handle *get_ti_sci_handle(void)
 	struct udevice *dev;
 	int ret;
 
-	ret = uclass_get_device_by_name(UCLASS_FIRMWARE, "dmsc", &dev);
+	ret = uclass_get_device(UCLASS_FIRMWARE, 0, &dev);
 	if (ret)
 		panic("Failed to get SYSFW (%d)\n", ret);
 
-- 
2.22.0