[U-Boot] [PATCH v1 18/20] configs: enable eSDHC device module for T1042D4RDB board

[Priyanka Jain]

>-----Original Message-----
>From: Yinbo Zhu <yinbo.zhu at nxp.com>
>Sent: Tuesday, September 17, 2019 8:26 AM
>To: Wolfgang Denk <wd at denx.de>; Priyanka Jain <priyanka.jain at nxp.com>;
>Shengzhou Liu <shengzhou.liu at nxp.com>; u-boot at lists.denx.de
>Cc: Yinbo Zhu <yinbo.zhu at nxp.com>; Xiaobo Xie <xiaobo.xie at nxp.com>;
>Jiafei Pan <jiafei.pan at nxp.com>; Prabhakar Kushwaha
><prabhakar.kushwaha at nxp.com>; Bin Meng <bmeng.cn at gmail.com>; Simon
>Goldschmidt <simon.k.r.goldschmidt at gmail.com>; Adam Ford
><aford173 at gmail.com>; Patrick Delaunay <patrick.delaunay at st.com>; Jeremy
>Gebben <jgebben at sweptlaser.com>; Joe Hershberger
><joe.hershberger at ni.com>; Y.b. Lu <yangbo.lu at nxp.com>
>Subject: [PATCH v1 18/20] configs: enable eSDHC device module for
>T1042D4RDB board
Better to add T1042D4RDB in prefix. Something like
configs: T1042D4RDB: enable eSDHC device module for
>
>This patch is to enable eSDHC device module for T1042D4RDB board
No need of string : "This patch is to"
>
>Signed-off-by: Yinbo Zhu <yinbo.zhu at nxp.com>
>---
<snip>

Same comments for other similar patches

priyankajain