[PATCH 09/11] net: dc2114x: Clean up INL/OUTL functions

[Marek Vasut]

Rename these functions to dc2114x_{inl,outl}(), use u32 values in
them instead of plain signed integers as all those values are in
fact register values and the driver code does bitwise operations
on them. No functional change intended.

Signed-off-by: Marek Vasut <marek.vasut+renesas at gmail.com>
Cc: Joe Hershberger <joe.hershberger at ni.com>
---
 drivers/net/dc2114x.c | 48 +++++++++++++++++++++----------------------
 1 file changed, 24 insertions(+), 24 deletions(-)

diff --git a/drivers/net/dc2114x.c b/drivers/net/dc2114x.c
index a85fb76d53..2bbe4e5d60 100644
--- a/drivers/net/dc2114x.c
+++ b/drivers/net/dc2114x.c
@@ -79,29 +79,29 @@
 #define phys_to_bus(a)	pci_phys_to_mem((pci_dev_t)dev->priv, a)
 #endif
 
-static int INL(struct eth_device *dev, u_long addr)
+static u32 dc2114x_inl(struct eth_device *dev, u32 addr)
 {
-	return le32_to_cpu(*(volatile u_long *)(addr + dev->iobase));
+	return le32_to_cpu(*(volatile u32 *)(addr + dev->iobase));
 }
 
-static void OUTL(struct eth_device *dev, int command, u_long addr)
+static void dc2114x_outl(struct eth_device *dev, u32 command, u32 addr)
 {
-	*(volatile u_long *)(addr + dev->iobase) = cpu_to_le32(command);
+	*(volatile u32 *)(addr + dev->iobase) = cpu_to_le32(command);
 }
 
 static void reset_de4x5(struct eth_device *dev)
 {
-	int i;
+	u32 i;
 
-	i = INL(dev, DE4X5_BMR);
+	i = dc2114x_inl(dev, DE4X5_BMR);
 	mdelay(1);
-	OUTL(dev, i | BMR_SWR, DE4X5_BMR);
+	dc2114x_outl(dev, i | BMR_SWR, DE4X5_BMR);
 	mdelay(1);
-	OUTL(dev, i, DE4X5_BMR);
+	dc2114x_outl(dev, i, DE4X5_BMR);
 	mdelay(1);
 
 	for (i = 0; i < 5; i++) {
-		INL(dev, DE4X5_BMR);
+		dc2114x_inl(dev, DE4X5_BMR);
 		mdelay(10);
 	}
 
@@ -110,20 +110,20 @@ static void reset_de4x5(struct eth_device *dev)
 
 static void start_de4x5(struct eth_device *dev)
 {
-	s32 omr;
+	u32 omr;
 
-	omr = INL(dev, DE4X5_OMR);
+	omr = dc2114x_inl(dev, DE4X5_OMR);
 	omr |= OMR_ST | OMR_SR;
-	OUTL(dev, omr, DE4X5_OMR);	/* Enable the TX and/or RX */
+	dc2114x_outl(dev, omr, DE4X5_OMR);	/* Enable the TX and/or RX */
 }
 
 static void stop_de4x5(struct eth_device *dev)
 {
-	s32 omr;
+	u32 omr;
 
-	omr = INL(dev, DE4X5_OMR);
+	omr = dc2114x_inl(dev, DE4X5_OMR);
 	omr &= ~(OMR_ST | OMR_SR);
-	OUTL(dev, omr, DE4X5_OMR);	/* Disable the TX and/or RX */
+	dc2114x_outl(dev, omr, DE4X5_OMR);	/* Disable the TX and/or RX */
 }
 
 #define NUM_RX_DESC PKTBUFSRX
@@ -270,12 +270,12 @@ static int dc21x4x_init(struct eth_device *dev, bd_t *bis)
 
 	reset_de4x5(dev);
 
-	if ((INL(dev, DE4X5_STS) & (STS_TS | STS_RS)) != 0) {
+	if (dc2114x_inl(dev, DE4X5_STS) & (STS_TS | STS_RS)) {
 		printf("Error: Cannot reset ethernet controller.\n");
 		return -1;
 	}
 
-	OUTL(dev, OMR_SDP | OMR_PS | OMR_PM, DE4X5_OMR);
+	dc2114x_outl(dev, OMR_SDP | OMR_PS | OMR_PM, DE4X5_OMR);
 
 	for (i = 0; i < NUM_RX_DESC; i++) {
 		rx_ring[i].status = cpu_to_le32(R_OWN);
@@ -300,8 +300,8 @@ static int dc21x4x_init(struct eth_device *dev, bd_t *bis)
 	tx_ring[tx_ring_size - 1].des1 |= cpu_to_le32(TD_TER);
 
 	/* Tell the adapter where the TX/RX rings are located. */
-	OUTL(dev, phys_to_bus((u32)&rx_ring), DE4X5_RRBA);
-	OUTL(dev, phys_to_bus((u32)&tx_ring), DE4X5_TRBA);
+	dc2114x_outl(dev, phys_to_bus((u32)&rx_ring), DE4X5_RRBA);
+	dc2114x_outl(dev, phys_to_bus((u32)&tx_ring), DE4X5_TRBA);
 
 	start_de4x5(dev);
 
@@ -335,7 +335,7 @@ static int dc21x4x_send(struct eth_device *dev, void *packet, int length)
 	tx_ring[tx_new].des1 = cpu_to_le32(TD_TER | TD_LS | TD_FS | length);
 	tx_ring[tx_new].status = cpu_to_le32(T_OWN);
 
-	OUTL(dev, POLL_DEMAND, DE4X5_TPD);
+	dc2114x_outl(dev, POLL_DEMAND, DE4X5_TPD);
 
 	for (i = 0; tx_ring[tx_new].status & cpu_to_le32(T_OWN); i++) {
 		if (i < TOUT_LOOP)
@@ -402,7 +402,7 @@ static void dc21x4x_halt(struct eth_device *dev)
 	int devbusfn = (int)dev->priv;
 
 	stop_de4x5(dev);
-	OUTL(dev, 0, DE4X5_SICR);
+	dc2114x_outl(dev, 0, DE4X5_SICR);
 
 	pci_write_config_byte(devbusfn, PCI_CFDA_PSM, SLEEP);
 }
@@ -433,7 +433,7 @@ static void send_setup_frame(struct eth_device *dev, bd_t *bis)
 	tx_ring[tx_new].des1 = cpu_to_le32(TD_TER | TD_SET | SETUP_FRAME_LEN);
 	tx_ring[tx_new].status = cpu_to_le32(T_OWN);
 
-	OUTL(dev, POLL_DEMAND, DE4X5_TPD);
+	dc2114x_outl(dev, POLL_DEMAND, DE4X5_TPD);
 
 	for (i = 0; tx_ring[tx_new].status & cpu_to_le32(T_OWN); i++) {
 		if (i < TOUT_LOOP)
@@ -454,13 +454,13 @@ static void send_setup_frame(struct eth_device *dev, bd_t *bis)
 /* SROM Read and write routines. */
 static void sendto_srom(struct eth_device *dev, u_int command, u_long addr)
 {
-	OUTL(dev, command, addr);
+	dc2114x_outl(dev, command, addr);
 	udelay(1);
 }
 
 static int getfrom_srom(struct eth_device *dev, u_long addr)
 {
-	s32 tmp = INL(dev, addr);
+	u32 tmp = dc2114x_inl(dev, addr);
 
 	udelay(1);
 	return tmp;
-- 
2.25.1