[PATCH v1 00/49] add support for broadcom NS3 soc

[Rayagonda Kokatanur]

This patch series adds support for Broadcom Northstar 3 SoC.
NS3 is a octo-core 64-bit ARMv8 Cortex-A72 processors
targeting a broad range of networking applications.

Abhishek Shah (1):
  board: ns3: add api to save boot parameters passed from BL31

Bharat Gooty (2):
  include/configs: ns3: add env variables for Linux boot
  include/configs: ns3: add support for flashing images

Bharat Kumar Reddy Gooty (3):
  board: ns3: program GIC LPI tables
  board: ns3: limit U-boot relocation within 16MB memory
  cmd: bcm: add command for chimp hand shake

Corneliu Doban (1):
  cmd: gpt: add eMMC and GPT support

Pramod Kumar (4):
  arm: dts: ns3: add emmc node
  arm: dts: ns3: add sp805 watchdog node
  board: ns3: add FIT image its file
  board: ns3: add development keys used in FIT

Rajesh Ravi (1):
  board: ns3: default reset type to L3

Ray Jui (1):
  board: ns3: define ddr memory layout

Rayagonda Kokatanur (27):
  board: ns3: add support for Broadcom Northstar 3
  arm: cpu: armv8: add L3 memory flush support
  configs: ns3: enable clock subsystem
  arm: dts: ns3: add clock dt node
  configs: ns3: enable pinctrl driver
  dt-bindings: pinctrl: add ns3 pads definition
  arm: dts: ns3: add pinctrl node
  arm: dts: ns3: add gpio node
  gpio: do not include <asm/arch/gpio.h> on TARGET_BCMNS3
  configs: ns3: enable BCM IPROC mmc driver
  configs: ns3: enable mmc commands
  arm: dts: ns3: add qspi node
  dt-bindings: memory: ns3: add memory definitions
  arm: dts: ns3: add i2c node
  configs: ns3: enable gpt commands
  configs: ns3: enable EXT4 and FAT fs support
  configs: ns3: enable sp805 watchdog driver
  board: ns3: start sp805 watchdog service
  dt-bindings: memory: ns3: update GIC LPI address
  configs: ns3: enable GIC ITS LPI table programing
  dt-bindings: memory: ns3: add ddr memory definition
  configs: ns3: enable FIT config
  configs: ns3: enable PXE boot command
  configs: ns3: enable RPMB
  configs: ns3: enable tee and optee driver
  configs: ns3: env in mmc
  board: ns3: check chimp handshake status

Sheetal Tigadoli (1):
  common: ns3: add error logging support

Srinath Mannam (1):
  arm: dts: ns3: add PAXB PCIe host and phy node

Trac Hoang (2):
  board: ns3: add generic MCU IPC command send API
  cmd: bcm: add nitro boot command

Vikas Gupta (3):
  board: ns3: add optee based bnxt fw load driver
  arm: dts: ns3: add optee node
  cmd: bcm: add nitro image load commands

Vladimir Olovyannikov (2):
  board: ns3: kconfig: extend board kconfig with specific commands
  cmd: bcm: add broadcom error log setup command

 arch/arm/Kconfig                              |  10 +
 arch/arm/cpu/armv8/Makefile                   |   1 +
 arch/arm/cpu/armv8/bcmns3/Makefile            |   5 +
 arch/arm/cpu/armv8/bcmns3/lowlevel.S          |  99 ++
 arch/arm/dts/Makefile                         |   2 +
 arch/arm/dts/ns3-board.dts                    | 105 ++
 arch/arm/dts/ns3-clock.dtsi                   |  34 +
 arch/arm/dts/ns3-pinctrl.dtsi                 | 321 +++++++
 arch/arm/dts/ns3.dtsi                         | 265 ++++++
 arch/arm/include/asm/arch-bcmns3/bl33_info.h  |  26 +
 arch/arm/include/asm/gpio.h                   |   2 +-
 board/broadcom/bcmns3/Kconfig                 |  25 +
 board/broadcom/bcmns3/Makefile                |   7 +
 board/broadcom/bcmns3/chimp_optee.c           | 154 +++
 board/broadcom/bcmns3/fit/keys/dev.crt        |  21 +
 board/broadcom/bcmns3/fit/keys/dev.key        |  28 +
 board/broadcom/bcmns3/fit/multi.its           |  59 ++
 board/broadcom/bcmns3/mcu_cmd.c               |  49 +
 board/broadcom/bcmns3/mcu_cmd.h               |  13 +
 board/broadcom/bcmns3/ns3.c                   | 263 +++++
 cmd/Kconfig                                   |   2 +
 cmd/Makefile                                  |   2 +
 cmd/bcm/Kconfig                               |  12 +
 cmd/bcm/Makefile                              |   7 +
 cmd/bcm/chimp_boot.c                          |  36 +
 cmd/bcm/chimp_handshake.c                     |  32 +
 cmd/bcm/elog.h                                |  64 ++
 cmd/bcm/logsetup.c                            | 432 +++++++++
 cmd/bcm/nitro_image_load.c                    |  99 ++
 cmd/gpt.c                                     |  95 ++
 common/Kconfig                                |   8 +
 common/Makefile                               |   1 +
 common/bcm_elog.c                             |  49 +
 common/console.c                              |  22 +
 configs/bcm_ns3_defconfig                     |  57 ++
 include/bcm_elog.h                            |  37 +
 include/brcm/chimp.h                          |  48 +
 include/configs/bcm_ns3.h                     | 901 ++++++++++++++++++
 include/dt-bindings/memory/bcm-ns3-mc.h       |  65 ++
 .../dt-bindings/pinctrl/brcm,pinctrl-ns3.h    |  41 +
 40 files changed, 3498 insertions(+), 1 deletion(-)
 create mode 100644 arch/arm/cpu/armv8/bcmns3/Makefile
 create mode 100644 arch/arm/cpu/armv8/bcmns3/lowlevel.S
 create mode 100644 arch/arm/dts/ns3-board.dts
 create mode 100644 arch/arm/dts/ns3-clock.dtsi
 create mode 100644 arch/arm/dts/ns3-pinctrl.dtsi
 create mode 100644 arch/arm/dts/ns3.dtsi
 create mode 100644 arch/arm/include/asm/arch-bcmns3/bl33_info.h
 create mode 100644 board/broadcom/bcmns3/Kconfig
 create mode 100644 board/broadcom/bcmns3/Makefile
 create mode 100644 board/broadcom/bcmns3/chimp_optee.c
 create mode 100644 board/broadcom/bcmns3/fit/keys/dev.crt
 create mode 100644 board/broadcom/bcmns3/fit/keys/dev.key
 create mode 100644 board/broadcom/bcmns3/fit/multi.its
 create mode 100644 board/broadcom/bcmns3/mcu_cmd.c
 create mode 100644 board/broadcom/bcmns3/mcu_cmd.h
 create mode 100644 board/broadcom/bcmns3/ns3.c
 create mode 100644 cmd/bcm/Kconfig
 create mode 100644 cmd/bcm/Makefile
 create mode 100644 cmd/bcm/chimp_boot.c
 create mode 100644 cmd/bcm/chimp_handshake.c
 create mode 100644 cmd/bcm/elog.h
 create mode 100644 cmd/bcm/logsetup.c
 create mode 100644 cmd/bcm/nitro_image_load.c
 create mode 100644 common/bcm_elog.c
 create mode 100644 configs/bcm_ns3_defconfig
 create mode 100644 include/bcm_elog.h
 create mode 100644 include/brcm/chimp.h
 create mode 100644 include/configs/bcm_ns3.h
 create mode 100644 include/dt-bindings/memory/bcm-ns3-mc.h
 create mode 100644 include/dt-bindings/pinctrl/brcm,pinctrl-ns3.h

-- 
2.17.1